tree f020ebd1df039717f5fe5fd7c5932d0df07a0f4a
parent 8add1ecb81f541ef2fcb0b85a5470ad9ecfb4a84
author Maciej W. Rozycki <macro@codesourcery.com> 1331065734 +0000
committer Ralf Baechle <ralf@linux-mips.org> 1355418927 +0100

MIPS: Handle COP3 Unusable exception as COP1X for FP emulation

 Our FP emulator is hardcoded for the MIPS IV FP instruction set and does
not match the FP ISA with the general ISA.  However for the few MIPS IV FP
instructions that use the COP1X major opcode it relies on the Coprocessor
Unusable exception to be delivered as a COP1 rather than COP3 exception.
This includes indexed transfer (LDXC1, etc.) and FP multiply-accumulate
(MADD.D, etc.) instructions.

 All the MIPS I, II, III and IV processors and some newer chips that do not
implement the FPU use the COP3 exception however.  Therefore I believe the
kernel should follow and redirect any COP3 Unusable traps to the emulator
unless an actual FPU part or core is present.

 This is a change that implements it.  Any minor opcode encodings that are
not recognised as valid FP instructions are rejected by the emulator and
will result in a SIGILL signal being delivered as they currently do.  We
do not support vendor-specific coprocessor 3 implementations supported
with MIPS I and MIPS II ISA processors; we never set CP0.Status.CU3.

[Ralf: On MIPS IV processors the kernel always enables the XX bit which
replaces the CU3 bit off earlier architecture revisions.]

 If matching between the CPU and the FPU ISA is considered required one
day, this can still be done in the emulator itself.  I think the CpU
exception dispatcher is not the right place to do this anyway, as there
are further differences between MIPS I, MIPS II, MIPS III, MIPS IV and
MIPS32 FP ISAs.

 Corresponding explanation of this implementation is included within the
change itself.

Signed-off-by: Maciej W. Rozycki <macro@codesourcery.com>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/project/linux-mips/list/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>