USB: ohci-omap: Use usb_put_transceiver instead of put_device
Currently usb_put_transceiver calls put_device so this is a no-op but it
is better to keep API usage consistent as ohci->transceiver is allocated
with usb_get_transceiver.
While at there remove one extra ohci->transceiver test as the code block
has already tested it.
Signed-off-by: Jarkko Nikula <jarkko.nikula@bitmer.com>
Acked-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ohci-omap.c b/drivers/usb/host/ohci-omap.c
index 96451e4..74b5320 100644
--- a/drivers/usb/host/ohci-omap.c
+++ b/drivers/usb/host/ohci-omap.c
@@ -217,8 +217,7 @@
dev_dbg(hcd->self.controller, "init %s transceiver, status %d\n",
ohci->transceiver->label, status);
if (status) {
- if (ohci->transceiver)
- put_device(ohci->transceiver->dev);
+ usb_put_transceiver(ohci->transceiver);
return status;
}
} else {
@@ -405,7 +404,7 @@
usb_remove_hcd(hcd);
if (ohci->transceiver) {
(void) otg_set_host(ohci->transceiver->otg, 0);
- put_device(ohci->transceiver->dev);
+ usb_put_transceiver(ohci->transceiver);
}
if (machine_is_omap_osk())
gpio_free(9);