[SCSI] qla2xxx: Correct LED scheme definition.
Original implementation used an overloaded bit in the EFI
parameters. The correct bit is BIT_4 of the special_options
section of NVRAM.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/qla2xxx/qla_def.h b/drivers/scsi/qla2xxx/qla_def.h
index cdef86e..b7f82b7 100644
--- a/drivers/scsi/qla2xxx/qla_def.h
+++ b/drivers/scsi/qla2xxx/qla_def.h
@@ -914,7 +914,7 @@
* MSB BIT 1 =
* MSB BIT 2 =
* MSB BIT 3 =
- * MSB BIT 4 =
+ * MSB BIT 4 = LED mode
* MSB BIT 5 = enable 50 ohm termination
* MSB BIT 6 = Data Rate (2300 only)
* MSB BIT 7 = Data Rate (2300 only)
@@ -1036,7 +1036,7 @@
* MSB BIT 1 =
* MSB BIT 2 =
* MSB BIT 3 =
- * MSB BIT 4 =
+ * MSB BIT 4 = LED mode
* MSB BIT 5 = enable 50 ohm termination
* MSB BIT 6 = Data Rate (2300 only)
* MSB BIT 7 = Data Rate (2300 only)