[SCSI] qla2xxx: Correct LED scheme definition.
Original implementation used an overloaded bit in the EFI
parameters. The correct bit is BIT_4 of the special_options
section of NVRAM.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index d12255f..c619583 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1564,7 +1564,7 @@
ha->flags.enable_lip_reset = ((nv->host_p[1] & BIT_1) ? 1 : 0);
ha->flags.enable_lip_full_login = ((nv->host_p[1] & BIT_2) ? 1 : 0);
ha->flags.enable_target_reset = ((nv->host_p[1] & BIT_3) ? 1 : 0);
- ha->flags.enable_led_scheme = ((nv->efi_parameters & BIT_3) ? 1 : 0);
+ ha->flags.enable_led_scheme = (nv->special_options[1] & BIT_4) ? 1 : 0;
ha->operating_mode =
(icb->add_firmware_options[0] & (BIT_6 | BIT_5 | BIT_4)) >> 4;