xircom_cb should return NETDEV_TX_BUSY when no descriptors available
Changes in other networking paths uncovered a bug in the xircom_cb
driver which made the kernel spew lots of the following error messages:
BUG eth1 code -5 qlen 0
It turned out that the driver returned -EIO when there was no
descriptor available for sending packets. It should return
NETDEV_TX_BUSY instead. This was discussed on the netdev list before,
see http://thread.gmane.org/gmane.linux.network/84603 .
Signed-off-by: Erik Mouw <mouw@nl.linux.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/tulip/xircom_cb.c b/drivers/net/tulip/xircom_cb.c
index 8fc7274..6b93d016 100644
--- a/drivers/net/tulip/xircom_cb.c
+++ b/drivers/net/tulip/xircom_cb.c
@@ -441,7 +441,7 @@
spin_unlock_irqrestore(&card->lock,flags);
trigger_transmit(card);
- return -EIO;
+ return NETDEV_TX_BUSY;
}