| /* |
| * arch/arm/mach-pxa/time.c |
| * |
| * Author: Nicolas Pitre |
| * Created: Jun 15, 2001 |
| * Copyright: MontaVista Software Inc. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/delay.h> |
| #include <linux/interrupt.h> |
| #include <linux/time.h> |
| #include <linux/signal.h> |
| #include <linux/errno.h> |
| #include <linux/sched.h> |
| #include <linux/clocksource.h> |
| |
| #include <asm/system.h> |
| #include <asm/hardware.h> |
| #include <asm/io.h> |
| #include <asm/leds.h> |
| #include <asm/irq.h> |
| #include <asm/mach/irq.h> |
| #include <asm/mach/time.h> |
| #include <asm/arch/pxa-regs.h> |
| |
| |
| static inline unsigned long pxa_get_rtc_time(void) |
| { |
| return RCNR; |
| } |
| |
| static int pxa_set_rtc(void) |
| { |
| unsigned long current_time = xtime.tv_sec; |
| |
| if (RTSR & RTSR_ALE) { |
| /* make sure not to forward the clock over an alarm */ |
| unsigned long alarm = RTAR; |
| if (current_time >= alarm && alarm >= RCNR) |
| return -ERESTARTSYS; |
| } |
| RCNR = current_time; |
| return 0; |
| } |
| |
| #ifdef CONFIG_NO_IDLE_HZ |
| static unsigned long initial_match; |
| static int match_posponed; |
| #endif |
| |
| static irqreturn_t |
| pxa_timer_interrupt(int irq, void *dev_id) |
| { |
| int next_match; |
| |
| write_seqlock(&xtime_lock); |
| |
| #ifdef CONFIG_NO_IDLE_HZ |
| if (match_posponed) { |
| match_posponed = 0; |
| OSMR0 = initial_match; |
| } |
| #endif |
| |
| /* Loop until we get ahead of the free running timer. |
| * This ensures an exact clock tick count and time accuracy. |
| * Since IRQs are disabled at this point, coherence between |
| * lost_ticks(updated in do_timer()) and the match reg value is |
| * ensured, hence we can use do_gettimeofday() from interrupt |
| * handlers. |
| * |
| * HACK ALERT: it seems that the PXA timer regs aren't updated right |
| * away in all cases when a write occurs. We therefore compare with |
| * 8 instead of 0 in the while() condition below to avoid missing a |
| * match if OSCR has already reached the next OSMR value. |
| * Experience has shown that up to 6 ticks are needed to work around |
| * this problem, but let's use 8 to be conservative. Note that this |
| * affect things only when the timer IRQ has been delayed by nearly |
| * exactly one tick period which should be a pretty rare event. |
| */ |
| do { |
| timer_tick(); |
| OSSR = OSSR_M0; /* Clear match on timer 0 */ |
| next_match = (OSMR0 += LATCH); |
| } while( (signed long)(next_match - OSCR) <= 8 ); |
| |
| write_sequnlock(&xtime_lock); |
| |
| return IRQ_HANDLED; |
| } |
| |
| static struct irqaction pxa_timer_irq = { |
| .name = "PXA Timer Tick", |
| .flags = IRQF_DISABLED | IRQF_TIMER | IRQF_IRQPOLL, |
| .handler = pxa_timer_interrupt, |
| }; |
| |
| static cycle_t pxa_get_cycles(void) |
| { |
| return OSCR; |
| } |
| |
| static struct clocksource clocksource_pxa = { |
| .name = "pxa_timer", |
| .rating = 200, |
| .read = pxa_get_cycles, |
| .mask = CLOCKSOURCE_MASK(32), |
| .shift = 20, |
| .flags = CLOCK_SOURCE_IS_CONTINUOUS, |
| }; |
| |
| static void __init pxa_timer_init(void) |
| { |
| struct timespec tv; |
| unsigned long flags; |
| |
| set_rtc = pxa_set_rtc; |
| |
| tv.tv_nsec = 0; |
| tv.tv_sec = pxa_get_rtc_time(); |
| do_settimeofday(&tv); |
| |
| OIER = 0; /* disable any timer interrupts */ |
| OSSR = 0xf; /* clear status on all timers */ |
| setup_irq(IRQ_OST0, &pxa_timer_irq); |
| local_irq_save(flags); |
| OIER = OIER_E0; /* enable match on timer 0 to cause interrupts */ |
| OSMR0 = OSCR + LATCH; /* set initial match */ |
| local_irq_restore(flags); |
| |
| /* |
| * OSCR runs continuously on PXA and is not written to, |
| * so we can use it as clock source directly. |
| */ |
| clocksource_pxa.mult = |
| clocksource_hz2mult(CLOCK_TICK_RATE, clocksource_pxa.shift); |
| clocksource_register(&clocksource_pxa); |
| } |
| |
| #ifdef CONFIG_NO_IDLE_HZ |
| static int pxa_dyn_tick_enable_disable(void) |
| { |
| /* nothing to do */ |
| return 0; |
| } |
| |
| static void pxa_dyn_tick_reprogram(unsigned long ticks) |
| { |
| if (ticks > 1) { |
| initial_match = OSMR0; |
| OSMR0 = initial_match + ticks * LATCH; |
| match_posponed = 1; |
| } |
| } |
| |
| static irqreturn_t |
| pxa_dyn_tick_handler(int irq, void *dev_id) |
| { |
| if (match_posponed) { |
| match_posponed = 0; |
| OSMR0 = initial_match; |
| if ( (signed long)(initial_match - OSCR) <= 8 ) |
| return pxa_timer_interrupt(irq, dev_id); |
| } |
| return IRQ_NONE; |
| } |
| |
| static struct dyn_tick_timer pxa_dyn_tick = { |
| .enable = pxa_dyn_tick_enable_disable, |
| .disable = pxa_dyn_tick_enable_disable, |
| .reprogram = pxa_dyn_tick_reprogram, |
| .handler = pxa_dyn_tick_handler, |
| }; |
| #endif |
| |
| #ifdef CONFIG_PM |
| static unsigned long osmr[4], oier; |
| |
| static void pxa_timer_suspend(void) |
| { |
| osmr[0] = OSMR0; |
| osmr[1] = OSMR1; |
| osmr[2] = OSMR2; |
| osmr[3] = OSMR3; |
| oier = OIER; |
| } |
| |
| static void pxa_timer_resume(void) |
| { |
| OSMR0 = osmr[0]; |
| OSMR1 = osmr[1]; |
| OSMR2 = osmr[2]; |
| OSMR3 = osmr[3]; |
| OIER = oier; |
| |
| /* |
| * OSMR0 is the system timer: make sure OSCR is sufficiently behind |
| */ |
| OSCR = OSMR0 - LATCH; |
| } |
| #else |
| #define pxa_timer_suspend NULL |
| #define pxa_timer_resume NULL |
| #endif |
| |
| struct sys_timer pxa_timer = { |
| .init = pxa_timer_init, |
| .suspend = pxa_timer_suspend, |
| .resume = pxa_timer_resume, |
| #ifdef CONFIG_NO_IDLE_HZ |
| .dyn_tick = &pxa_dyn_tick, |
| #endif |
| }; |