ipmi: Improve error messages on failed irq enable
When the interrupt enable message returns an error, the messages are
not entirely accurate nor helpful. So improve them.
Signed-off-by: Corey Minyard <cminyard@mvista.com>
Cc: Andy Lutomirski <luto@amacapital.net>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/char/ipmi/ipmi_si_intf.c b/drivers/char/ipmi/ipmi_si_intf.c
index 313538a..af4b23f 100644
--- a/drivers/char/ipmi/ipmi_si_intf.c
+++ b/drivers/char/ipmi/ipmi_si_intf.c
@@ -663,8 +663,10 @@
/* We got the flags from the SMI, now handle them. */
smi_info->handlers->get_result(smi_info->si_sm, msg, 4);
if (msg[2] != 0) {
- dev_warn(smi_info->dev, "Could not enable interrupts"
- ", failed get, using polled mode.\n");
+ dev_warn(smi_info->dev,
+ "Couldn't get irq info: %x.\n", msg[2]);
+ dev_warn(smi_info->dev,
+ "Maybe ok, but ipmi might run very slowly.\n");
smi_info->si_state = SI_NORMAL;
} else {
msg[0] = (IPMI_NETFN_APP_REQUEST << 2);
@@ -685,10 +687,12 @@
/* We got the flags from the SMI, now handle them. */
smi_info->handlers->get_result(smi_info->si_sm, msg, 4);
- if (msg[2] != 0)
- dev_warn(smi_info->dev, "Could not enable interrupts"
- ", failed set, using polled mode.\n");
- else
+ if (msg[2] != 0) {
+ dev_warn(smi_info->dev,
+ "Couldn't set irq info: %x.\n", msg[2]);
+ dev_warn(smi_info->dev,
+ "Maybe ok, but ipmi might run very slowly.\n");
+ } else
smi_info->interrupt_disabled = 0;
smi_info->si_state = SI_NORMAL;
break;