diff --git a/Documentation/usb/usbmon.txt b/Documentation/usb/usbmon.txt
index 53ae866a..2917ce4 100644
--- a/Documentation/usb/usbmon.txt
+++ b/Documentation/usb/usbmon.txt
@@ -34,9 +34,12 @@
 Verify that bus sockets are present.
 
 # ls /sys/kernel/debug/usbmon
-1s  1t  1u  2s  2t  2u  3s  3t  3u  4s  4t  4u
+0s  0t  0u  1s  1t  1u  2s  2t  2u  3s  3t  3u  4s  4t  4u
 #
 
+Now you can choose to either use the sockets numbered '0' (to capture packets on
+all buses), and skip to step #3, or find the bus used by your device with step #2.
+
 2. Find which bus connects to the desired device
 
 Run "cat /proc/bus/usb/devices", and find the T-line which corresponds to
@@ -56,6 +59,10 @@
 
 # cat /sys/kernel/debug/usbmon/3u > /tmp/1.mon.out
 
+to listen on a single bus, otherwise, to listen on all buses, type:
+
+# cat /sys/kernel/debug/usbmon/0u > /tmp/1.mon.out
+
 This process will be reading until killed. Naturally, the output can be
 redirected to a desirable location. This is preferred, because it is going
 to be quite long.