[SCSI] lpfc 8.2.4 : Miscellaneous Fixes
Miscellaneous Fixes:
- Fix a couple of sparse complaints
- Reset the FCP recovery flag when the node is not a FCP2 device.
- Speed up offline prep delays
- Fixed a memory leak in lpfc_mem_alloc failure path
- Fixed external loopback test.
- Fixed error code returned from the driver when HBA is over heated.
- Correct Max NPIV vport to limits read from adapter
- Add missing locks around fc_flag and FC_NEEDS_REG_VPI
- Add missing hba ids for device identification
- Added support for SET_VARIABLE and MBX_WRITE_WWN mailbox commands
- Changed all temperature event messages from warning to error
- Fix reporting of link speed when link is down
- Added support for MBX_WRITE_WWN mailbox command
- Change del_timer_sync() in ISR to del_timer() in interrupt handler
- Correct instances of beXX_to_cpu() that should be cpu_to_beXX()
- Perform target flush before releasing node references on module unload
- Avoid bogus devloss_tmo messages when driver unloads
- Fix panic when HBA generates ERATT interupt
- Fix mbox race condition and a workaround on back-to-back mailbox commands
- Force NPIV off for pt2pt mode between 2 NPorts
- Stop worker thread before removing fc_host.
- Fix up discovery timeout error case due to missing clear_la
- Tighten mailbox polling code to speed up detection of fast completions
- Only allow DUMP_MEMORY if adapter offline due to overtemp errors
- Added extended error information to the log messages in chip init.
Signed-off-by: James Smart <James.Smart@emulex.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/lpfc/lpfc_hw.h b/drivers/scsi/lpfc/lpfc_hw.h
index b61e45a..f78d23a 100644
--- a/drivers/scsi/lpfc/lpfc_hw.h
+++ b/drivers/scsi/lpfc/lpfc_hw.h
@@ -1279,7 +1279,7 @@
#define MBX_DEL_LD_ENTRY 0x1D
#define MBX_RUN_PROGRAM 0x1E
#define MBX_SET_MASK 0x20
-#define MBX_SET_SLIM 0x21
+#define MBX_SET_VARIABLE 0x21
#define MBX_UNREG_D_ID 0x23
#define MBX_KILL_BOARD 0x24
#define MBX_CONFIG_FARP 0x25
@@ -1301,7 +1301,7 @@
#define MBX_REG_VNPID 0x96
#define MBX_UNREG_VNPID 0x97
-#define MBX_FLASH_WR_ULA 0x98
+#define MBX_WRITE_WWN 0x98
#define MBX_SET_DEBUG 0x99
#define MBX_LOAD_EXP_ROM 0x9C
@@ -3227,6 +3227,8 @@
(device == PCI_DEVICE_ID_BSMB) ||
(device == PCI_DEVICE_ID_ZMID) ||
(device == PCI_DEVICE_ID_ZSMB) ||
+ (device == PCI_DEVICE_ID_SAT_MID) ||
+ (device == PCI_DEVICE_ID_SAT_SMB) ||
(device == PCI_DEVICE_ID_RFLY))
return 1;
else