qede: Fix DMA address APIs usage
Driver incorrectly uses dma_unmap_addr_set() to set
a variable which is in truth a dma_addr_t
[i.e not defined using DEFINE_DMA_UNMAP_ADDR()] and is
being used by the driver flows other than unmapping
physical addresses. This patch fixes driver fastpath
where CONFIG_NEED_DMA_MAP_STATE is not set.
Signed-off-by: Manish Chopra <manish.chopra@qlogic.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qede/qede_main.c b/drivers/net/ethernet/qlogic/qede/qede_main.c
index 8114541..901a9acc 100644
--- a/drivers/net/ethernet/qlogic/qede/qede_main.c
+++ b/drivers/net/ethernet/qlogic/qede/qede_main.c
@@ -1076,8 +1076,7 @@
* start until its over and we don't want to risk allocation failing
* here, so re-allocate when aggregation will be over.
*/
- dma_unmap_addr_set(sw_rx_data_prod, mapping,
- dma_unmap_addr(replace_buf, mapping));
+ sw_rx_data_prod->mapping = replace_buf->mapping;
sw_rx_data_prod->data = replace_buf->data;
rx_bd_prod->addr.hi = cpu_to_le32(upper_32_bits(mapping));
@@ -2655,7 +2654,7 @@
if (replace_buf->data) {
dma_unmap_page(&edev->pdev->dev,
- dma_unmap_addr(replace_buf, mapping),
+ replace_buf->mapping,
PAGE_SIZE, DMA_FROM_DEVICE);
__free_page(replace_buf->data);
}
@@ -2755,7 +2754,7 @@
goto err;
}
- dma_unmap_addr_set(replace_buf, mapping, mapping);
+ replace_buf->mapping = mapping;
tpa_info->replace_buf.page_offset = 0;
tpa_info->replace_buf_mapping = mapping;