cpufreq: cpufreq-dt: Improve debug about matching OPP
During test of new DT OPPs it's very helpful to print the matching
OPP in case of frequency change. So it will be easier to find frequency
rounding issues in the dts file.
Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Acked-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/cpufreq/cpufreq-dt.c b/drivers/cpufreq/cpufreq-dt.c
index f657c57..725fb1d 100644
--- a/drivers/cpufreq/cpufreq-dt.c
+++ b/drivers/cpufreq/cpufreq-dt.c
@@ -58,6 +58,8 @@
old_freq = clk_get_rate(cpu_clk) / 1000;
if (!IS_ERR(cpu_reg)) {
+ unsigned long opp_freq;
+
rcu_read_lock();
opp = dev_pm_opp_find_freq_ceil(cpu_dev, &freq_Hz);
if (IS_ERR(opp)) {
@@ -67,9 +69,12 @@
return PTR_ERR(opp);
}
volt = dev_pm_opp_get_voltage(opp);
+ opp_freq = dev_pm_opp_get_freq(opp);
rcu_read_unlock();
tol = volt * priv->voltage_tolerance / 100;
volt_old = regulator_get_voltage(cpu_reg);
+ dev_dbg(cpu_dev, "Found OPP: %ld kHz, %ld uV\n",
+ opp_freq / 1000, volt);
}
dev_dbg(cpu_dev, "%u MHz, %ld mV --> %u MHz, %ld mV\n",