bnx2x: 57840 non-external loopback test fail on 1G
when 1G-optic module was plugged in, internal loopback test failed because the
driver used to check the optic module (with no need), and for 1G optic module,
the link speed was forced down to 1G, while the XMAC (10G MAC) was enabled.
This patch avoid accessing optic module in case internal loopback was selected,
and update the link speed in case 1G optic module was detected during init
stage.
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index 84798bb..5c6d46c 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
@@ -4523,10 +4523,14 @@
* enabled transmitter to avoid current leakage in case
* no module is connected
*/
- if (bnx2x_is_sfp_module_plugged(phy, params))
- bnx2x_sfp_module_detection(phy, params);
- else
- bnx2x_sfp_e3_set_transmitter(params, phy, 1);
+ if ((params->loopback_mode == LOOPBACK_NONE) ||
+ (params->loopback_mode == LOOPBACK_EXT)) {
+ if (bnx2x_is_sfp_module_plugged(phy, params))
+ bnx2x_sfp_module_detection(phy, params);
+ else
+ bnx2x_sfp_e3_set_transmitter(params,
+ phy, 1);
+ }
bnx2x_warpcore_config_sfi(phy, params);
break;
@@ -6528,6 +6532,11 @@
params->phy[INT_PHY].config_init(phy, params, vars);
}
+ /* Re-read this value in case it was changed inside config_init due to
+ * limitations of optic module
+ */
+ vars->line_speed = params->phy[INT_PHY].req_line_speed;
+
/* Init external phy*/
if (non_ext_phy) {
if (params->phy[INT_PHY].supported &