qlcnic: Fix protcol type in case of inband vlan.
o Use correct l3 (ETH_IP or ETH_IPV6)protcol in case
of inband vlan. Because of incorrect protcol type driver
was setting incorrect opcode. This resulted in adapter calculating
checksum incorrectly.
o Updated driver version to 5.0.29
Signed-off-by: Rajesh Borundia <rajesh.borundia@qlogic.com>
Signed-off-by: Anirban Chakraborty <anirban.chakraborty@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
index 707b5ca..33c3e46 100644
--- a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
+++ b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_main.c
@@ -2033,6 +2033,7 @@
vh = (struct vlan_ethhdr *)skb->data;
flags = FLAGS_VLAN_TAGGED;
vlan_tci = vh->h_vlan_TCI;
+ protocol = ntohs(vh->h_vlan_encapsulated_proto);
} else if (vlan_tx_tag_present(skb)) {
flags = FLAGS_VLAN_OOB;
vlan_tci = vlan_tx_tag_get(skb);