ixgbe: add device support for 82598AT (copper 10GbE) adapters
Intel is currently shipping support for adapters with a phy
that does 10GBase-T (copper), which is 10 Gigabit ethernet
over standard Category 6 cabling.
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/net/ixgbe/ixgbe_ethtool.c b/drivers/net/ixgbe/ixgbe_ethtool.c
index 81a9c4b..fee56a3 100644
--- a/drivers/net/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ixgbe/ixgbe_ethtool.c
@@ -149,6 +149,8 @@
{
struct ixgbe_adapter *adapter = netdev_priv(netdev);
struct ixgbe_hw *hw = &adapter->hw;
+ u32 advertised, old;
+ s32 err;
switch (hw->phy.media_type) {
case ixgbe_media_type_fiber:
@@ -157,6 +159,31 @@
return -EINVAL;
/* in this case we currently only support 10Gb/FULL */
break;
+ case ixgbe_media_type_copper:
+ /* 10000/copper and 1000/copper must autoneg
+ * this function does not support any duplex forcing, but can
+ * limit the advertising of the adapter to only 10000 or 1000 */
+ if (ecmd->autoneg == AUTONEG_DISABLE)
+ return -EINVAL;
+
+ old = hw->phy.autoneg_advertised;
+ advertised = 0;
+ if (ecmd->advertising & ADVERTISED_10000baseT_Full)
+ advertised |= IXGBE_LINK_SPEED_10GB_FULL;
+
+ if (ecmd->advertising & ADVERTISED_1000baseT_Full)
+ advertised |= IXGBE_LINK_SPEED_1GB_FULL;
+
+ if (old == advertised)
+ break;
+ /* this sets the link speed and restarts auto-neg */
+ err = hw->mac.ops.setup_link_speed(hw, advertised, true, true);
+ if (err) {
+ DPRINTK(PROBE, INFO,
+ "setup link failed with code %d\n", err);
+ hw->mac.ops.setup_link_speed(hw, old, true, true);
+ }
+ break;
default:
break;
}