iwlwifi: fix spelling errors
Fix spelling error across the driver.
Modified only comments and prints.
Signed-off-by: Sara Sharon <sara.sharon@intel.com>
Reviewed-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-trans.h b/drivers/net/wireless/iwlwifi/iwl-trans.h
index 11ac5c5..6dfed12 100644
--- a/drivers/net/wireless/iwlwifi/iwl-trans.h
+++ b/drivers/net/wireless/iwlwifi/iwl-trans.h
@@ -77,10 +77,10 @@
/**
* DOC: Transport layer - what is it ?
*
- * The tranport layer is the layer that deals with the HW directly. It provides
+ * The transport layer is the layer that deals with the HW directly. It provides
* an abstraction of the underlying HW to the upper layer. The transport layer
* doesn't provide any policy, algorithm or anything of this kind, but only
- * mechanisms to make the HW do something.It is not completely stateless but
+ * mechanisms to make the HW do something. It is not completely stateless but
* close to it.
* We will have an implementation for each different supported bus.
*/
@@ -111,10 +111,10 @@
/**
* DOC: Host command section
*
- * A host command is a commaned issued by the upper layer to the fw. There are
+ * A host command is a command issued by the upper layer to the fw. There are
* several versions of fw that have several APIs. The transport layer is
* completely agnostic to these differences.
- * The transport does provide helper functionnality (i.e. SYNC / ASYNC mode),
+ * The transport does provide helper functionality (i.e. SYNC / ASYNC mode),
*/
#define SEQ_TO_QUEUE(s) (((s) >> 8) & 0x1f)
#define QUEUE_TO_SEQ(q) (((q) & 0x1f) << 8)
@@ -195,7 +195,7 @@
* @CMD_WANT_SKB: Not valid with CMD_ASYNC. The caller needs the buffer of
* the response. The caller needs to call iwl_free_resp when done.
* @CMD_HIGH_PRIO: The command is high priority - it goes to the front of the
- * command queue, but after other high priority commands. valid only
+ * command queue, but after other high priority commands. Valid only
* with CMD_ASYNC.
* @CMD_SEND_IN_IDLE: The command should be sent even when the trans is idle.
* @CMD_MAKE_TRANS_IDLE: The command response should mark the trans as idle.
@@ -582,7 +582,7 @@
* @cfg - pointer to the configuration
* @status: a bit-mask of transport status flags
* @dev - pointer to struct device * that represents the device
- * @hw_id: a u32 with the ID of the device / subdevice.
+ * @hw_id: a u32 with the ID of the device / sub-device.
* Set during transport allocation.
* @hw_id_str: a string with info about HW ID. Set during transport allocation.
* @pm_support: set to true in start_hw if link pm is supported