bnx2x: Adjust BCM84833 to BCM578xx
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Vladislav Zolotarov <vladz@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@conan.davemloft.net>
diff --git a/drivers/net/bnx2x/bnx2x_main.c b/drivers/net/bnx2x/bnx2x_main.c
index 0dddba9..29c6702 100644
--- a/drivers/net/bnx2x/bnx2x_main.c
+++ b/drivers/net/bnx2x/bnx2x_main.c
@@ -1955,6 +1955,53 @@
return 0;
}
+int bnx2x_set_mult_gpio(struct bnx2x *bp, u8 pins, u32 mode)
+{
+ u32 gpio_reg = 0;
+ int rc = 0;
+
+ /* Any port swapping should be handled by caller. */
+
+ bnx2x_acquire_hw_lock(bp, HW_LOCK_RESOURCE_GPIO);
+ /* read GPIO and mask except the float bits */
+ gpio_reg = REG_RD(bp, MISC_REG_GPIO);
+ gpio_reg &= ~(pins << MISC_REGISTERS_GPIO_FLOAT_POS);
+ gpio_reg &= ~(pins << MISC_REGISTERS_GPIO_CLR_POS);
+ gpio_reg &= ~(pins << MISC_REGISTERS_GPIO_SET_POS);
+
+ switch (mode) {
+ case MISC_REGISTERS_GPIO_OUTPUT_LOW:
+ DP(NETIF_MSG_LINK, "Set GPIO 0x%x -> output low\n", pins);
+ /* set CLR */
+ gpio_reg |= (pins << MISC_REGISTERS_GPIO_CLR_POS);
+ break;
+
+ case MISC_REGISTERS_GPIO_OUTPUT_HIGH:
+ DP(NETIF_MSG_LINK, "Set GPIO 0x%x -> output high\n", pins);
+ /* set SET */
+ gpio_reg |= (pins << MISC_REGISTERS_GPIO_SET_POS);
+ break;
+
+ case MISC_REGISTERS_GPIO_INPUT_HI_Z:
+ DP(NETIF_MSG_LINK, "Set GPIO 0x%x -> input\n", pins);
+ /* set FLOAT */
+ gpio_reg |= (pins << MISC_REGISTERS_GPIO_FLOAT_POS);
+ break;
+
+ default:
+ BNX2X_ERR("Invalid GPIO mode assignment %d\n", mode);
+ rc = -EINVAL;
+ break;
+ }
+
+ if (rc == 0)
+ REG_WR(bp, MISC_REG_GPIO, gpio_reg);
+
+ bnx2x_release_hw_lock(bp, HW_LOCK_RESOURCE_GPIO);
+
+ return rc;
+}
+
int bnx2x_set_gpio_int(struct bnx2x *bp, int gpio_num, u32 mode, u8 port)
{
/* The GPIO should be swapped if swap register is set and active */