mac80211: enable Auth Protocol Identifier on mesh config.
Previously the mesh_auth_id was disabled. Instead set the
correct mesh authentication bit based on the mesh setup.
Signed-off-by: Colleen Twitty <colleen@cozybit.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/cfg.c b/net/mac80211/cfg.c
index 6698945..eb42190 100644
--- a/net/mac80211/cfg.c
+++ b/net/mac80211/cfg.c
@@ -1746,6 +1746,7 @@
ifmsh->mesh_pp_id = setup->path_sel_proto;
ifmsh->mesh_pm_id = setup->path_metric;
ifmsh->user_mpm = setup->user_mpm;
+ ifmsh->mesh_auth_id = setup->auth_id;
ifmsh->security = IEEE80211_MESH_SEC_NONE;
if (setup->is_authenticated)
ifmsh->security |= IEEE80211_MESH_SEC_AUTHED;
diff --git a/net/mac80211/mesh.c b/net/mac80211/mesh.c
index 6952760..c13db9a 100644
--- a/net/mac80211/mesh.c
+++ b/net/mac80211/mesh.c
@@ -748,7 +748,6 @@
ieee80211_configure_filter(local);
ifmsh->mesh_cc_id = 0; /* Disabled */
- ifmsh->mesh_auth_id = 0; /* Disabled */
/* register sync ops from extensible synchronization framework */
ifmsh->sync_ops = ieee80211_mesh_sync_ops_get(ifmsh->mesh_sp_id);
ifmsh->adjusting_tbtt = false;