libata: convert to iomap
Convert libata core layer and LLDs to use iomap.
* managed iomap is used. Pointer to pcim_iomap_table() is cached at
host->iomap and used through out LLDs. This basically replaces
host->mmio_base.
* if possible, pcim_iomap_regions() is used
Most iomap operation conversions are taken from Jeff Garzik
<jgarzik@pobox.com>'s iomap branch.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_hpt3x2n.c b/drivers/ata/pata_hpt3x2n.c
index 9f8ec57..b56dc4a 100644
--- a/drivers/ata/pata_hpt3x2n.c
+++ b/drivers/ata/pata_hpt3x2n.c
@@ -263,26 +263,26 @@
static void hpt3x2n_set_clock(struct ata_port *ap, int source)
{
- unsigned long bmdma = ap->ioaddr.bmdma_addr;
+ void __iomem *bmdma = ap->ioaddr.bmdma_addr;
/* Tristate the bus */
- outb(0x80, bmdma+0x73);
- outb(0x80, bmdma+0x77);
+ iowrite8(0x80, bmdma+0x73);
+ iowrite8(0x80, bmdma+0x77);
/* Switch clock and reset channels */
- outb(source, bmdma+0x7B);
- outb(0xC0, bmdma+0x79);
+ iowrite8(source, bmdma+0x7B);
+ iowrite8(0xC0, bmdma+0x79);
/* Reset state machines */
- outb(0x37, bmdma+0x70);
- outb(0x37, bmdma+0x74);
+ iowrite8(0x37, bmdma+0x70);
+ iowrite8(0x37, bmdma+0x74);
/* Complete reset */
- outb(0x00, bmdma+0x79);
+ iowrite8(0x00, bmdma+0x79);
/* Reconnect channels to bus */
- outb(0x00, bmdma+0x73);
- outb(0x00, bmdma+0x77);
+ iowrite8(0x00, bmdma+0x73);
+ iowrite8(0x00, bmdma+0x77);
}
/* Check if our partner interface is busy */
@@ -373,7 +373,7 @@
.qc_prep = ata_qc_prep,
.qc_issue = hpt3x2n_qc_issue_prot,
- .data_xfer = ata_pio_data_xfer,
+ .data_xfer = ata_data_xfer,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,