libata: convert to iomap
Convert libata core layer and LLDs to use iomap.
* managed iomap is used. Pointer to pcim_iomap_table() is cached at
host->iomap and used through out LLDs. This basically replaces
host->mmio_base.
* if possible, pcim_iomap_regions() is used
Most iomap operation conversions are taken from Jeff Garzik
<jgarzik@pobox.com>'s iomap branch.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_pdc202xx_old.c b/drivers/ata/pata_pdc202xx_old.c
index c52e1e8..7e194d8 100644
--- a/drivers/ata/pata_pdc202xx_old.c
+++ b/drivers/ata/pata_pdc202xx_old.c
@@ -170,17 +170,17 @@
struct ata_taskfile *tf = &qc->tf;
int sel66 = ap->port_no ? 0x08: 0x02;
- unsigned long master = ap->host->ports[0]->ioaddr.bmdma_addr;
- unsigned long clock = master + 0x11;
- unsigned long atapi_reg = master + 0x20 + (4 * ap->port_no);
+ void __iomem *master = ap->host->ports[0]->ioaddr.bmdma_addr;
+ void __iomem *clock = master + 0x11;
+ void __iomem *atapi_reg = master + 0x20 + (4 * ap->port_no);
u32 len;
/* Check we keep host level locking here */
if (adev->dma_mode >= XFER_UDMA_2)
- outb(inb(clock) | sel66, clock);
+ iowrite8(ioread8(clock) | sel66, clock);
else
- outb(inb(clock) & ~sel66, clock);
+ iowrite8(ioread8(clock) & ~sel66, clock);
/* The DMA clocks may have been trashed by a reset. FIXME: make conditional
and move to qc_issue ? */
@@ -196,7 +196,7 @@
else
len |= 0x05000000;
- outl(len, atapi_reg);
+ iowrite32(len, atapi_reg);
}
/* Activate DMA */
@@ -219,19 +219,19 @@
int sel66 = ap->port_no ? 0x08: 0x02;
/* The clock bits are in the same register for both channels */
- unsigned long master = ap->host->ports[0]->ioaddr.bmdma_addr;
- unsigned long clock = master + 0x11;
- unsigned long atapi_reg = master + 0x20 + (4 * ap->port_no);
+ void __iomem *master = ap->host->ports[0]->ioaddr.bmdma_addr;
+ void __iomem *clock = master + 0x11;
+ void __iomem *atapi_reg = master + 0x20 + (4 * ap->port_no);
/* Cases the state machine will not complete correctly */
if (tf->protocol == ATA_PROT_ATAPI_DMA || ( tf->flags & ATA_TFLAG_LBA48)) {
- outl(0, atapi_reg);
- outb(inb(clock) & ~sel66, clock);
+ iowrite32(0, atapi_reg);
+ iowrite8(ioread8(clock) & ~sel66, clock);
}
/* Check we keep host level locking here */
/* Flip back to 33Mhz for PIO */
if (adev->dma_mode >= XFER_UDMA_2)
- outb(inb(clock) & ~sel66, clock);
+ iowrite8(ioread8(clock) & ~sel66, clock);
ata_bmdma_stop(qc);
}
@@ -294,7 +294,7 @@
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .data_xfer = ata_pio_data_xfer,
+ .data_xfer = ata_data_xfer,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
@@ -326,7 +326,7 @@
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .data_xfer = ata_pio_data_xfer,
+ .data_xfer = ata_data_xfer,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,