qlcnic: disable tx timeout recovery
Disable tx timeout recovery, if auto_fw_reset is disable
Signed-off-by: Amit Kumar Salecha <amit.salecha@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/qlcnic/qlcnic_main.c b/drivers/net/qlcnic/qlcnic_main.c
index 4d18313..0fef8c3 100644
--- a/drivers/net/qlcnic/qlcnic_main.c
+++ b/drivers/net/qlcnic/qlcnic_main.c
@@ -2581,7 +2581,8 @@
if (adapter->need_fw_reset)
goto detach;
- if (adapter->reset_context) {
+ if (adapter->reset_context &&
+ auto_fw_reset == AUTO_FW_RESET_ENABLED) {
qlcnic_reset_hw_context(adapter);
adapter->netdev->trans_start = jiffies;
}
@@ -2594,7 +2595,8 @@
qlcnic_dev_request_reset(adapter);
- clear_bit(__QLCNIC_FW_ATTACHED, &adapter->state);
+ if ((auto_fw_reset == AUTO_FW_RESET_ENABLED))
+ clear_bit(__QLCNIC_FW_ATTACHED, &adapter->state);
dev_info(&netdev->dev, "firmware hang detected\n");