asus-laptop: add wireless and bluetooth status parameter
These to parameter allow to set the status of wlan and bluetooth
device when the module load. On some models, the device will
always be down on boot, so the default behavior is to always
enable these devices.
Signed-off-by: Corentin Chary <corentincj@iksaif.net>
diff --git a/drivers/platform/x86/asus-laptop.c b/drivers/platform/x86/asus-laptop.c
index 61a1c75..1d799b3 100644
--- a/drivers/platform/x86/asus-laptop.c
+++ b/drivers/platform/x86/asus-laptop.c
@@ -113,6 +113,19 @@
module_param(wapf, uint, 0644);
MODULE_PARM_DESC(wapf, "WAPF value");
+static uint wireless_status = 1;
+static uint bluetooth_status = 1;
+
+module_param(wireless_status, uint, 0644);
+MODULE_PARM_DESC(wireless_status, "Set the wireless status on boot "
+ "(0 = disabled, 1 = enabled, -1 = don't do anything). "
+ "default is 1");
+
+module_param(bluetooth_status, uint, 0644);
+MODULE_PARM_DESC(bluetooth_status, "Set the wireless status on boot "
+ "(0 = disabled, 1 = enabled, -1 = don't do anything). "
+ "default is 1");
+
#define ASUS_HANDLE(object, paths...) \
static acpi_handle object##_handle = NULL; \
static char *object##_paths[] = { paths }
@@ -1272,8 +1285,10 @@
asus_hotk_found = 1;
/* WLED and BLED are on by default */
- write_status(bt_switch_handle, 1, BT_ON);
- write_status(wl_switch_handle, 1, WL_ON);
+ if (bluetooth_status != -1)
+ write_status(bt_switch_handle, !!bluetooth_status, BT_ON);
+ if (wireless_status != -1)
+ write_status(wl_switch_handle, !!wireless_status, WL_ON);
/* If the h/w switch is off, we need to check the real status */
write_status(NULL, read_status(BT_ON), BT_ON);