bnx2x: Add support for ethtool -L
Add support for ethtool -L/-l for setting and getting the number of RSS queues.
The 'combined' field is used as we don't support separate IRQ for Rx and Tx.
Signed-off-by: Merav Sicron <meravs@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
index 1ebcaa1..08c8d7d 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
@@ -104,7 +104,7 @@
#define INT_MODE_INTx 1
#define INT_MODE_MSI 2
-static int int_mode;
+int int_mode;
module_param(int_mode, int, 0);
MODULE_PARM_DESC(int_mode, " Force interrupt mode other than MSI-X "
"(1 INT#x; 2 MSI)");
@@ -7612,7 +7612,7 @@
*
* In case of MSI-X it will also try to enable MSI-X.
*/
-static void __devinit bnx2x_set_int_mode(struct bnx2x *bp)
+void bnx2x_set_int_mode(struct bnx2x *bp)
{
switch (int_mode) {
case INT_MODE_MSI:
@@ -7623,11 +7623,6 @@
BNX2X_DEV_INFO("set number of queues to 1\n");
break;
default:
- /* Set number of queues for MSI-X mode */
- bnx2x_set_num_queues(bp);
-
- BNX2X_DEV_INFO("set number of queues to %d\n", bp->num_queues);
-
/* if we can't use MSI-X we only need one fp,
* so try to enable MSI-X with the requested number of fp's
* and fallback to MSI or legacy INTx with one fp
@@ -11883,8 +11878,12 @@
#endif
+
+ /* Set bp->num_queues for MSI-X mode*/
+ bnx2x_set_num_queues(bp);
+
/* Configure interrupt mode: try to enable MSI-X/MSI if
- * needed, set bp->num_queues appropriately.
+ * needed.
*/
bnx2x_set_int_mode(bp);