ath5k: Stop queues only for NF calibration
As far as we know, only NF calibration interferes with RX/TX so we can
leave the queues enabled for the other calibrations.
BTW: Stopping the queues is not enough for avoiding transmissions, since there
might be packets in the queue + beacons are also sent regularly! But i leave it
like this until we have a better solution (stopping TX DMA?).
Signed-off-by: Bruno Randolf <br1@einfach.org>
Acked-by: Nick Kossifidis <mickflemm@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index 3d854f0..78a0c42 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -2786,10 +2786,6 @@
/* Only full calibration for now */
ah->ah_cal_mask |= AR5K_CALIBRATION_FULL;
- /* Stop queues so that calibration
- * doesn't interfere with tx */
- ieee80211_stop_queues(sc->hw);
-
ATH5K_DBG(sc, ATH5K_DEBUG_CALIBRATE, "channel %u/%x\n",
ieee80211_frequency_to_channel(sc->curchan->center_freq),
sc->curchan->hw_value);
@@ -2807,8 +2803,13 @@
ieee80211_frequency_to_channel(
sc->curchan->center_freq));
+ /* TODO: We don't need to run noise floor calibration as often
+ * as I/Q calibration.*/
+
+ /* Noise floor calibration interrupts rx/tx path while I/Q calibration
+ * doesn't. Stop queues so that calibration doesn't interfere with tx */
+ ieee80211_stop_queues(sc->hw);
ath5k_hw_update_noise_floor(ah);
- /* Wake queues */
ieee80211_wake_queues(sc->hw);
ah->ah_cal_mask &= ~AR5K_CALIBRATION_FULL;