| # |
| # IPv6 configuration |
| # |
| |
| # IPv6 as module will cause a CRASH if you try to unload it |
| config IPV6 |
| tristate "The IPv6 protocol" |
| default m |
| select CRYPTO if IPV6_PRIVACY |
| select CRYPTO_MD5 if IPV6_PRIVACY |
| ---help--- |
| This is complemental support for the IP version 6. |
| You will still be able to do traditional IPv4 networking as well. |
| |
| For general information about IPv6, see |
| <http://playground.sun.com/pub/ipng/html/ipng-main.html>. |
| For Linux IPv6 development information, see <http://www.linux-ipv6.org>. |
| For specific information about IPv6 under Linux, read the HOWTO at |
| <http://www.bieringer.de/linux/IPv6/>. |
| |
| To compile this protocol support as a module, choose M here: the |
| module will be called ipv6. |
| |
| config IPV6_PRIVACY |
| bool "IPv6: Privacy Extensions (RFC 3041) support" |
| depends on IPV6 |
| ---help--- |
| Privacy Extensions for Stateless Address Autoconfiguration in IPv6 |
| support. With this option, additional periodically-alter |
| pseudo-random global-scope unicast address(es) will assigned to |
| your interface(s). |
| |
| By default, kernel do not generate temporary addresses. |
| To use temporary addresses, do |
| |
| echo 2 >/proc/sys/net/ipv6/conf/all/use_tempaddr |
| |
| See <file:Documentation/networking/ip-sysctl.txt> for details. |
| |
| config INET6_AH |
| tristate "IPv6: AH transformation" |
| depends on IPV6 |
| select XFRM |
| select CRYPTO |
| select CRYPTO_HMAC |
| select CRYPTO_MD5 |
| select CRYPTO_SHA1 |
| ---help--- |
| Support for IPsec AH. |
| |
| If unsure, say Y. |
| |
| config INET6_ESP |
| tristate "IPv6: ESP transformation" |
| depends on IPV6 |
| select XFRM |
| select CRYPTO |
| select CRYPTO_HMAC |
| select CRYPTO_MD5 |
| select CRYPTO_SHA1 |
| select CRYPTO_DES |
| ---help--- |
| Support for IPsec ESP. |
| |
| If unsure, say Y. |
| |
| config INET6_IPCOMP |
| tristate "IPv6: IPComp transformation" |
| depends on IPV6 |
| select XFRM |
| select INET6_TUNNEL |
| select CRYPTO |
| select CRYPTO_DEFLATE |
| ---help--- |
| Support for IP Payload Compression Protocol (IPComp) (RFC3173), |
| typically needed for IPsec. |
| |
| If unsure, say Y. |
| |
| config INET6_TUNNEL |
| tristate "IPv6: tunnel transformation" |
| depends on IPV6 |
| select XFRM |
| ---help--- |
| Support for generic IPv6-in-IPv6 tunnel transformation, which is |
| required by the IPv6-in-IPv6 tunneling module as well as tunnel mode |
| IPComp. |
| |
| If unsure, say Y. |
| |
| config IPV6_TUNNEL |
| tristate "IPv6: IPv6-in-IPv6 tunnel" |
| depends on IPV6 |
| select INET6_TUNNEL |
| ---help--- |
| Support for IPv6-in-IPv6 tunnels described in RFC 2473. |
| |
| If unsure, say N. |
| |