diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c
index b572a12..9adaf5f 100644
--- a/drivers/net/e1000/e1000_main.c
+++ b/drivers/net/e1000/e1000_main.c
@@ -29,6 +29,23 @@
 #include "e1000.h"
 
 /* Change Log
+ * 7.0.33      3-Feb-2006
+ *   o Added another fix for the pass false carrier bit
+ * 7.0.32      24-Jan-2006
+ *   o Need to rebuild with noew version number for the pass false carrier 
+ *     fix in e1000_hw.c
+ * 7.0.30      18-Jan-2006
+ *   o fixup for tso workaround to disable it for pci-x
+ *   o fix mem leak on 82542
+ *   o fixes for 10 Mb/s connections and incorrect stats
+ * 7.0.28      01/06/2006
+ *   o hardware workaround to only set "speed mode" bit for 1G link.
+ * 7.0.26      12/23/2005
+ *   o wake on lan support modified for device ID 10B5
+ *   o fix dhcp + vlan issue not making it to the iAMT firmware
+ * 7.0.24      12/9/2005
+ *   o New hardware support for the Gigabit NIC embedded in the south bridge
+ *   o Fixes to the recycling logic (skb->tail) from IBM LTC
  * 6.3.9	12/16/2005
  *   o incorporate fix for recycled skbs from IBM LTC
  * 6.3.7	11/18/2005
@@ -46,54 +63,8 @@
  *     rx_buffer_len
  * 6.3.1	9/19/05
  *   o Use adapter->tx_timeout_factor in Tx Hung Detect logic 
-       (e1000_clean_tx_irq)
+ *      (e1000_clean_tx_irq)
  *   o Support for 8086:10B5 device (Quad Port)
- * 6.2.14	9/15/05
- *   o In AMT enabled configurations, set/reset DRV_LOAD bit on interface 
- *     open/close 
- * 6.2.13       9/14/05
- *   o Invoke e1000_check_mng_mode only for 8257x controllers since it 
- *     accesses the FWSM that is not supported in other controllers
- * 6.2.12       9/9/05
- *   o Add support for device id E1000_DEV_ID_82546GB_QUAD_COPPER
- *   o set RCTL:SECRC only for controllers newer than 82543. 
- *   o When the n/w interface comes down reset DRV_LOAD bit to notify f/w.
- *     This code was moved from e1000_remove to e1000_close
- * 6.2.10       9/6/05
- *   o Fix error in updating RDT in el1000_alloc_rx_buffers[_ps] -- one off.
- *   o Enable fc by default on 82573 controllers (do not read eeprom)
- *   o Fix rx_errors statistic not to include missed_packet_count
- *   o Fix rx_dropped statistic not to include missed_packet_count 
-       (Padraig Brady)
- * 6.2.9        8/30/05
- *   o Remove call to update statistics from the controller ib e1000_get_stats
- * 6.2.8        8/30/05
- *   o Improved algorithm for rx buffer allocation/rdt update
- *   o Flow control watermarks relative to rx PBA size
- *   o Simplified 'Tx Hung' detect logic
- * 6.2.7 	8/17/05
- *   o Report rx buffer allocation failures and tx timeout counts in stats
- * 6.2.6 	8/16/05
- *   o Implement workaround for controller erratum -- linear non-tso packet
- *     following a TSO gets written back prematurely
- * 6.2.5	8/15/05
- *   o Set netdev->tx_queue_len based on link speed/duplex settings.
- *   o Fix net_stats.rx_fifo_errors <p@draigBrady.com>
- *   o Do not power off PHY if SoL/IDER session is active
- * 6.2.4	8/10/05
- *   o Fix loopback test setup/cleanup for 82571/3 controllers
- *   o Fix parsing of outgoing packets (e1000_transfer_dhcp_info) to treat
- *     all packets as raw
- *   o Prevent operations that will cause the PHY to be reset if SoL/IDER
- *     sessions are active and log a message
- * 6.2.2	7/21/05
- *   o used fixed size descriptors for all MTU sizes, reduces memory load
- * 6.1.2	4/13/05
- *   o Fixed ethtool diagnostics
- *   o Enabled flow control to take default eeprom settings
- *   o Added stats_lock around e1000_read_phy_reg commands to avoid concurrent
- *     calls, one from mii_ioctl and other from within update_stats while 
- *     processing MIIREG ioctl.
  */
 
 char e1000_driver_name[] = "e1000";
@@ -178,13 +149,13 @@
 void e1000_free_all_tx_resources(struct e1000_adapter *adapter);
 void e1000_free_all_rx_resources(struct e1000_adapter *adapter);
 static int e1000_setup_tx_resources(struct e1000_adapter *adapter,
-				    struct e1000_tx_ring *txdr);
+                                    struct e1000_tx_ring *txdr);
 static int e1000_setup_rx_resources(struct e1000_adapter *adapter,
-				    struct e1000_rx_ring *rxdr);
+                                    struct e1000_rx_ring *rxdr);
 static void e1000_free_tx_resources(struct e1000_adapter *adapter,
-				    struct e1000_tx_ring *tx_ring);
+                                    struct e1000_tx_ring *tx_ring);
 static void e1000_free_rx_resources(struct e1000_adapter *adapter,
-				    struct e1000_rx_ring *rx_ring);
+                                    struct e1000_rx_ring *rx_ring);
 void e1000_update_stats(struct e1000_adapter *adapter);
 
 /* Local Function Prototypes */
@@ -1727,6 +1698,7 @@
 	uint32_t rdlen, rctl, rxcsum, ctrl_ext;
 
 	if (adapter->rx_ps_pages) {
+		/* this is a 32 byte descriptor */
 		rdlen = adapter->rx_ring[0].count *
 			sizeof(union e1000_rx_desc_packet_split);
 		adapter->clean_rx = e1000_clean_rx_irq_ps;
@@ -2576,9 +2548,9 @@
 		/* Workaround for Controller erratum --
 		 * descriptor for non-tso packet in a linear SKB that follows a
 		 * tso gets written back prematurely before the data is fully
-		 * DMAd to the controller */
+		 * DMA'd to the controller */
 		if (!skb->data_len && tx_ring->last_tx_tso &&
-				!skb_shinfo(skb)->tso_size) {
+		    !skb_shinfo(skb)->tso_size) {
 			tx_ring->last_tx_tso = 0;
 			size -= 4;
 		}
@@ -2866,7 +2838,7 @@
 #ifdef NETIF_F_TSO
 	/* Controller Erratum workaround */
 	if (!skb->data_len && tx_ring->last_tx_tso &&
-		!skb_shinfo(skb)->tso_size)
+	    !skb_shinfo(skb)->tso_size)
 		count++;
 #endif
 
@@ -2889,7 +2861,9 @@
 	if (adapter->pcix_82544)
 		count += nr_frags;
 
-	if (adapter->hw.tx_pkt_filtering && (adapter->hw.mac_type == e1000_82573) )
+
+	if (adapter->hw.tx_pkt_filtering &&
+	    (adapter->hw.mac_type == e1000_82573))
 		e1000_transfer_dhcp_info(adapter, skb);
 
 	local_irq_save(flags);
@@ -3892,7 +3866,6 @@
 			goto map_skb;
 		}
 
-
 		if (unlikely(!skb)) {
 			/* Better luck next round */
 			adapter->alloc_rx_buff_failed++;
@@ -4445,8 +4418,8 @@
 }
 
 #ifdef CONFIG_PM
-/* these functions save and restore 16 or 64 dwords (64-256 bytes) of config
- * space versus the 64 bytes that pci_[save|restore]_state handle
+/* Save/restore 16 or 64 dwords of PCI config space depending on which
+ * bus we're on (PCI(X) vs. PCI-E)
  */
 #define PCIE_CONFIG_SPACE_LEN 256
 #define PCI_CONFIG_SPACE_LEN 64
@@ -4456,6 +4429,7 @@
 	struct pci_dev *dev = adapter->pdev;
 	int size;
 	int i;
+
 	if (adapter->hw.mac_type >= e1000_82571)
 		size = PCIE_CONFIG_SPACE_LEN;
 	else
@@ -4479,8 +4453,10 @@
 	struct pci_dev *dev = adapter->pdev;
 	int size;
 	int i;
+
 	if (adapter->config_space == NULL)
 		return;
+
 	if (adapter->hw.mac_type >= e1000_82571)
 		size = PCIE_CONFIG_SPACE_LEN;
 	else
@@ -4508,8 +4484,8 @@
 		e1000_down(adapter);
 
 #ifdef CONFIG_PM
-	/* implement our own version of pci_save_state(pdev) because pci 
-	 * express adapters have larger 256 byte config spaces */
+	/* Implement our own version of pci_save_state(pdev) because pci-
+	 * express adapters have 256-byte config spaces. */
 	retval = e1000_pci_save_state(adapter);
 	if (retval)
 		return retval;
@@ -4566,7 +4542,7 @@
 		retval = pci_enable_wake(pdev, PCI_D3hot, 0);
 		if (retval)
 			DPRINTK(PROBE, ERR, "Error enabling D3 wake\n");
-		retval = pci_enable_wake(pdev, PCI_D3cold, 0); /* 4 == D3 cold */
+		retval = pci_enable_wake(pdev, PCI_D3cold, 0);
 		if (retval)
 			DPRINTK(PROBE, ERR, "Error enabling D3 cold wake\n");
 	}
@@ -4582,7 +4558,8 @@
 				DPRINTK(PROBE, ERR, "Error enabling D3 wake\n");
 			retval = pci_enable_wake(pdev, PCI_D3cold, 1);
 			if (retval)
-				DPRINTK(PROBE, ERR, "Error enabling D3 cold wake\n");
+				DPRINTK(PROBE, ERR,
+				        "Error enabling D3 cold wake\n");
 		}
 	}