mmc: Fixes for Dual Data Rate (DDR) support
The DDR support patch needs the following fixes:
- The block driver does not need to know about DDR, any more
than it needs to know about bus width.
- Not only the card must be switched to DDR mode. The host
controller must also be configured, which is done through
the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
is successful.
- Setting block length is not supported in DDR mode. Make that
a core function and change the other place it is used (mmc_test)
also.
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/card/block.c b/drivers/mmc/card/block.c
index aab5934..a997050 100644
--- a/drivers/mmc/card/block.c
+++ b/drivers/mmc/card/block.c
@@ -373,8 +373,6 @@
readcmd = MMC_READ_SINGLE_BLOCK;
writecmd = MMC_WRITE_BLOCK;
}
- if (mmc_card_ddr_mode(card))
- brq.data.flags |= MMC_DDR_MODE;
if (rq_data_dir(req) == READ) {
brq.cmd.opcode = readcmd;
brq.data.flags |= MMC_DATA_READ;
@@ -653,26 +651,15 @@
static int
mmc_blk_set_blksize(struct mmc_blk_data *md, struct mmc_card *card)
{
- struct mmc_command cmd;
int err;
- /*
- * Block-addressed and ddr mode supported cards
- * ignore MMC_SET_BLOCKLEN.
- */
- if (mmc_card_blockaddr(card) || mmc_card_ddr_mode(card))
- return 0;
-
mmc_claim_host(card->host);
- cmd.opcode = MMC_SET_BLOCKLEN;
- cmd.arg = 512;
- cmd.flags = MMC_RSP_SPI_R1 | MMC_RSP_R1 | MMC_CMD_AC;
- err = mmc_wait_for_cmd(card->host, &cmd, 5);
+ err = mmc_set_blocklen(card, 512);
mmc_release_host(card->host);
if (err) {
- printk(KERN_ERR "%s: unable to set block size to %d: %d\n",
- md->disk->disk_name, cmd.arg, err);
+ printk(KERN_ERR "%s: unable to set block size to 512: %d\n",
+ md->disk->disk_name, err);
return -EINVAL;
}
diff --git a/drivers/mmc/card/mmc_test.c b/drivers/mmc/card/mmc_test.c
index c38a3a8..21adc27 100644
--- a/drivers/mmc/card/mmc_test.c
+++ b/drivers/mmc/card/mmc_test.c
@@ -155,17 +155,7 @@
*/
static int mmc_test_set_blksize(struct mmc_test_card *test, unsigned size)
{
- struct mmc_command cmd;
- int ret;
-
- cmd.opcode = MMC_SET_BLOCKLEN;
- cmd.arg = size;
- cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
- ret = mmc_wait_for_cmd(test->card->host, &cmd, 0);
- if (ret)
- return ret;
-
- return 0;
+ return mmc_set_blocklen(test->card, size);
}
/*