Bluetooth: hciuart: Add support QCA chipset for UART
QCA61x4 chips have supported sleep feature using In-Band-Sleep commands
to enable sleep feature based on H4 protocol. After sending
patch/nvm configuration is done, IBS mode will be up and running
Signed-off-by: Ben Young Tae Kim <ytkim@qca.qualcomm.com>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
index f580334..0bd88c9 100644
--- a/drivers/bluetooth/Kconfig
+++ b/drivers/bluetooth/Kconfig
@@ -155,6 +155,19 @@
Say Y here to compile support for Broadcom protocol.
+config BT_HCIUART_QCA
+ bool "Qualcomm Atheros protocol support"
+ depends on BT_HCIUART
+ select BT_HCIUART_H4
+ select BT_QCA
+ help
+ The Qualcomm Atheros protocol supports HCI In-Band Sleep feature
+ over serial port interface(H4) between controller and host.
+ This protocol is required for UART clock control for QCA Bluetooth
+ devices.
+
+ Say Y here to compile support for QCA protocol.
+
config BT_HCIBCM203X
tristate "HCI BCM203x USB driver"
depends on USB