PCI: make PME# messages KERN_DEBUG
Messages about PME# being supported and enabled/disabled are probably
useful for debug, but maybe don't need to be on the console.
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index f0da167..930eadf 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -1211,7 +1211,7 @@
pci_write_config_word(dev, dev->pm_cap + PCI_PM_CTRL, pmcsr);
- dev_printk(KERN_INFO, &dev->dev, "PME# %s\n",
+ dev_printk(KERN_DEBUG, &dev->dev, "PME# %s\n",
enable ? "enabled" : "disabled");
}
@@ -1422,7 +1422,8 @@
pmc &= PCI_PM_CAP_PME_MASK;
if (pmc) {
- dev_info(&dev->dev, "PME# supported from%s%s%s%s%s\n",
+ dev_printk(KERN_DEBUG, &dev->dev,
+ "PME# supported from%s%s%s%s%s\n",
(pmc & PCI_PM_CAP_PME_D0) ? " D0" : "",
(pmc & PCI_PM_CAP_PME_D1) ? " D1" : "",
(pmc & PCI_PM_CAP_PME_D2) ? " D2" : "",