[PATCH] PCI: remove PCI_BRIDGE_CTL_VGA handling from setup-bus.c
The setup-bus code doesn't work correctly for configurations
with more than one display adapter in the same PCI domain.
This stuff actually is a leftover of an early 2.4 PCI setup code
and apparently it stopped working after some "bridge_ctl" changes.
So the best thing we can do is just to remove it and rely on the fact
that any firmware *has* to configure VGA port forwarding for the boot
display device properly.
But then we need to ensure that the bus->bridge_ctl will always
contain valid information collected at the probe time, therefore
the following change in pci_scan_bridge() is needed.
Signed-off-by: Ivan Kokshaysky <ink@jurassic.park.msu.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
index df3bdae..93e8a87 100644
--- a/drivers/pci/probe.c
+++ b/drivers/pci/probe.c
@@ -507,7 +507,7 @@
pci_write_config_dword(dev, PCI_PRIMARY_BUS, buses);
if (!is_cardbus) {
- child->bridge_ctl = PCI_BRIDGE_CTL_NO_ISA;
+ child->bridge_ctl = bctl | PCI_BRIDGE_CTL_NO_ISA;
/*
* Adjust subordinate busnr in parent buses.
* We do this before scanning for children because