[SCSI] bfa: Brocade-1860 Fabric Adapter Hardware Enablement
- Added support for Brocade-1860 Fabric Adapter.
- Made changes to support single firmware image per asic type.
- Combined bfi_cbreg.h and bfi_ctreg.h defines into bfi_reg.h with
only minimal defines used by host.
- Added changes to setup CPE/RME Queue register offsets based on
firmware response.
- Removed queue register offset initializations and added register offsets
to BFI config response message.
- Added Brocade-1860 asic specific interrupt status definitions and
mailbox interfaces.
Signed-off-by: Krishna Gudipati <kgudipat@brocade.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/bfa/bfa.h b/drivers/scsi/bfa/bfa.h
index 7be6b5a..708bab0 100644
--- a/drivers/scsi/bfa/bfa.h
+++ b/drivers/scsi/bfa/bfa.h
@@ -136,7 +136,6 @@
struct list_head qe;
bfa_cb_cbfn_t cbfn;
bfa_boolean_t once;
- u32 rsvd;
void *cbarg;
};
@@ -205,11 +204,9 @@
void __iomem *intr_mask;
void __iomem *cpe_q_pi[BFI_IOC_MAX_CQS];
void __iomem *cpe_q_ci[BFI_IOC_MAX_CQS];
- void __iomem *cpe_q_depth[BFI_IOC_MAX_CQS];
void __iomem *cpe_q_ctrl[BFI_IOC_MAX_CQS];
void __iomem *rme_q_ci[BFI_IOC_MAX_CQS];
void __iomem *rme_q_pi[BFI_IOC_MAX_CQS];
- void __iomem *rme_q_depth[BFI_IOC_MAX_CQS];
void __iomem *rme_q_ctrl[BFI_IOC_MAX_CQS];
};
@@ -238,6 +235,8 @@
u32 *nvecs, u32 *maxvec);
void (*hw_msix_get_rme_range) (struct bfa_s *bfa, u32 *start,
u32 *end);
+ int cpe_vec_q0;
+ int rme_vec_q0;
};
typedef void (*bfa_cb_iocfc_t) (void *cbarg, enum bfa_status status);
@@ -257,7 +256,6 @@
struct bfi_iocfc_cfg_s *cfginfo;
struct bfa_dma_s cfgrsp_dma;
struct bfi_iocfc_cfgrsp_s *cfgrsp;
- struct bfi_iocfc_cfg_reply_s *cfg_reply;
struct bfa_dma_s req_cq_ba[BFI_IOC_MAX_CQS];
struct bfa_dma_s req_cq_shadow_ci[BFI_IOC_MAX_CQS];
struct bfa_dma_s rsp_cq_ba[BFI_IOC_MAX_CQS];
@@ -277,8 +275,11 @@
((__bfa)->iocfc.hwif.hw_msix_install(__bfa))
#define bfa_msix_uninstall(__bfa) \
((__bfa)->iocfc.hwif.hw_msix_uninstall(__bfa))
-#define bfa_isr_mode_set(__bfa, __msix) \
- ((__bfa)->iocfc.hwif.hw_isr_mode_set(__bfa, __msix))
+#define bfa_isr_mode_set(__bfa, __msix) do { \
+ if ((__bfa)->iocfc.hwif.hw_isr_mode_set) \
+ (__bfa)->iocfc.hwif.hw_isr_mode_set(__bfa, __msix); \
+} while (0)
+
#define bfa_msix_getvecs(__bfa, __vecmap, __nvecs, __maxvec) \
((__bfa)->iocfc.hwif.hw_msix_getvecs(__bfa, __vecmap, \
__nvecs, __maxvec))
@@ -321,6 +322,7 @@
void bfa_hwcb_msix_get_rme_range(struct bfa_s *bfa, u32 *start,
u32 *end);
void bfa_hwct_reginit(struct bfa_s *bfa);
+void bfa_hwct2_reginit(struct bfa_s *bfa);
void bfa_hwct_reqq_ack(struct bfa_s *bfa, int rspq);
void bfa_hwct_rspq_ack(struct bfa_s *bfa, int rspq);
void bfa_hwct_msix_init(struct bfa_s *bfa, int nvecs);