[PATCH] Framebuffer driver for Arc LCD board
Add support for the Arc monochrome LCD board.
The board uses KS108 controllers to drive individual 64x64 LCD matrices.
The board can be paneled in a variety of setups such as 2x1=128x64,
4x4=256x256 and so on. The board/host interface is through GPIO.
Signed-off-by: Jaya Kumar <jayalk@intworks.biz>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Cc: <linux-fbdev-devel@lists.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/video/Kconfig b/drivers/video/Kconfig
index 6be8fbe..04d3120 100644
--- a/drivers/video/Kconfig
+++ b/drivers/video/Kconfig
@@ -322,6 +322,22 @@
This is the frame buffer device driver for the Amiga FrameMaster
card from BSC (exhibited 1992 but not shipped as a CBM product).
+config FB_ARC
+ tristate "Arc Monochrome LCD board support"
+ depends on FB && X86
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ select FB_SOFT_CURSOR
+ help
+ This enables support for the Arc Monochrome LCD board. The board
+ is based on the KS-108 lcd controller and is typically a matrix
+ of 2*n chips. This driver was tested with a 128x64 panel. This
+ driver supports it for use with x86 SBCs through a 16 bit GPIO
+ interface (8 bit data, 8 bit control). If you anticpate using
+ this driver, say Y or M; otherwise say N. You must specify the
+ GPIO IO address to be used for setting control and data.
+
config FB_ATARI
bool "Atari native chipset support"
depends on (FB = y) && ATARI && BROKEN