Merge tag 'imx6-dt-3.15' of git://git.linaro.org/people/shawnguo/linux-2.6 into next/dt

Merge "i.MX6 device tree changes for 3.15" from Shawn Guo:

 - A good number of new i.MX6 boards support: cm-fx6, dmo-edmqmx6,
   nitrogen6x, Gateworks Ventana gw5xxx family, DFI FS700-M60 and
   Zealz GK802
 - Update imx6q-sabrelite device tree and add Dual Lite/Solo support
 - Move pins that are used by particular client device out of hog group
 - Use GPIO_6 for FEC interrupt to workaround a hardware bug (ERR006687
   ENET: Only the ENET wake-up interrupt request can wake the system
   from Wait mode.)
 - Make pinctrl nodes board specific to avoid floating board specific
   device tree blob with so many unused pinctrl data
 - Use generic node name for fixed regulator
 - Update OPP table for cpufreq support
 - Random updates on various board device tree sources, adding pinctrl
   settings, device nodes, properties, etc.

* tag 'imx6-dt-3.15' of git://git.linaro.org/people/shawnguo/linux-2.6: (62 commits)
  ARM: dts: imx6q: Add support for Zealz GK802
  ARM: dts: imx6: Add DFI FS700-M60 board support
  ARM: dts: imx6: use imx51-ssi
  ARM: dts: imx6qdl: Add mmc aliases
  ARM: dts: imx6q: Add spi4 alias
  ARM: dts: imx6qdl-sabreauto: Add LVDS support
  ARM: dts: imx6sl: add keypad support for i.mx6sl-evk board.
  ARM: dts: imx6sl: add ocram device support
  ARM: dts: imx6qdl: enable dma for spi
  ARM: dts: imx6qdl-sabresd: Add PFUZE100 support
  ARM: dts: imx6: add mxs phy controller id
  ARM: dts: imx6: add anatop phandle for usbphy
  ARM: dts: imx6q-arm2: use GPIO_6 for FEC interrupt.
  ARM: dts: imx6qdl-sabreauto: use GPIO_6 for FEC interrupt.
  ARM: dts: imx6qdl-sabrelite: use GPIO_6 for FEC interrupt.
  ARM: dts: imx6qdl: use interrupts-extended for fec
  ARM: dts: imx: pinfunc: add MX6QDL_PAD_GPIO_6__ENET_IRQ
  ARM: dts: imx6q-sabrelite: PHY reset is active-low
  ARM: dts: imx6: Use 'vddarm' as the regulator name
  ARM: dts: imx6qdl-sabresd: Add power key support
  ...