ide: use 'drive->dn & 1' instead of drive->select.b.unit
* Call ide_port_init_devices() in ide_host_register()
also if 'struct ide_port_info *d' is not available.
* Init drive->dn in ide_port_init_devices() instead of
ide_probe_port() so it is valid also in ->init_dev.
* Pass device number to ide_dev_apply_params().
* Use 'drive->dn & 1' instead of drive->select.b.unit.
There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/pci/serverworks.c b/drivers/ide/pci/serverworks.c
index 3dff2ae..7fac801 100644
--- a/drivers/ide/pci/serverworks.c
+++ b/drivers/ide/pci/serverworks.c
@@ -153,7 +153,7 @@
ide_hwif_t *hwif = HWIF(drive);
struct pci_dev *dev = to_pci_dev(hwif->dev);
- u8 unit = (drive->select.b.unit & 0x01);
+ u8 unit = drive->dn & 1;
u8 ultra_enable = 0, ultra_timing = 0, dma_timing = 0;