ide: use 'drive->dn & 1' instead of drive->select.b.unit
* Call ide_port_init_devices() in ide_host_register()
also if 'struct ide_port_info *d' is not available.
* Init drive->dn in ide_port_init_devices() instead of
ide_probe_port() so it is valid also in ->init_dev.
* Pass device number to ide_dev_apply_params().
* Use 'drive->dn & 1' instead of drive->select.b.unit.
There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/pci/triflex.c b/drivers/ide/pci/triflex.c
index be8715d..42fb98f 100644
--- a/drivers/ide/pci/triflex.c
+++ b/drivers/ide/pci/triflex.c
@@ -38,13 +38,12 @@
{
ide_hwif_t *hwif = HWIF(drive);
struct pci_dev *dev = to_pci_dev(hwif->dev);
- u8 channel_offset = hwif->channel ? 0x74 : 0x70;
- u16 timing = 0;
u32 triflex_timings = 0;
- u8 unit = (drive->select.b.unit & 0x01);
-
+ u16 timing = 0;
+ u8 channel_offset = hwif->channel ? 0x74 : 0x70, unit = drive->dn & 1;
+
pci_read_config_dword(dev, channel_offset, &triflex_timings);
-
+
switch(speed) {
case XFER_MW_DMA_2:
timing = 0x0103;