drm/i915: Always call the adjusted mode 'adjusted_mode'
Always name any variable pointing at the adjusted mode as
'adjustead_mode'. This will make it much easier to identify
when we should use the crtc_ timings and when we shoudln't.
Conversion was performed with coccinelle:
@@
expression E;
identifier I;
@@
- struct drm_display_mode *I = &E.adjusted_mode;
+ struct drm_display_mode *adjusted_mode = &E.adjusted_mode;
<...
- I
+ adjusted_mode
...>
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Reviewed-by: Mika Kahola <mika.kahola@intel.com>
[danvet: Fixup conflicts.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index 61d69c2..23b7fc5 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -774,8 +774,7 @@
struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->crtc);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(encoder);
- struct drm_display_mode *adjusted_mode =
- &intel_crtc->config->base.adjusted_mode;
+ struct drm_display_mode *adjusted_mode = &intel_crtc->config->base.adjusted_mode;
enum port port;
unsigned int bpp = intel_crtc->config->pipe_bpp;
u32 val, tmp;
@@ -880,14 +879,14 @@
intel_dsi->video_mode_format == VIDEO_MODE_BURST) {
I915_WRITE(MIPI_HS_TX_TIMEOUT(port),
txbyteclkhs(adjusted_mode->htotal, bpp,
- intel_dsi->lane_count,
- intel_dsi->burst_mode_ratio) + 1);
+ intel_dsi->lane_count,
+ intel_dsi->burst_mode_ratio) + 1);
} else {
I915_WRITE(MIPI_HS_TX_TIMEOUT(port),
txbyteclkhs(adjusted_mode->vtotal *
- adjusted_mode->htotal,
- bpp, intel_dsi->lane_count,
- intel_dsi->burst_mode_ratio) + 1);
+ adjusted_mode->htotal,
+ bpp, intel_dsi->lane_count,
+ intel_dsi->burst_mode_ratio) + 1);
}
I915_WRITE(MIPI_LP_RX_TIMEOUT(port), intel_dsi->lp_rx_timeout);
I915_WRITE(MIPI_TURN_AROUND_TIMEOUT(port),