diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
index 17df6db..cb947a1 100644
--- a/drivers/gpio/gpio-davinci.c
+++ b/drivers/gpio/gpio-davinci.c
@@ -31,6 +31,8 @@
 	u32	intstat;
 };
 
+#define BINTEN	0x8 /* GPIO Interrupt Per-Bank Enable Register */
+
 #define chip2controller(chip)	\
 	container_of(chip, struct davinci_gpio_controller, chip)
 
@@ -304,7 +306,8 @@
 {
 	struct davinci_soc_info *soc_info = &davinci_soc_info;
 
-	/* NOTE:  we assume for now that only irqs in the first gpio_chip
+	/*
+	 * NOTE:  we assume for now that only irqs in the first gpio_chip
 	 * can provide direct-mapped IRQs to AINTC (up to 32 GPIOs).
 	 */
 	if (offset < soc_info->gpio_unbanked)
@@ -368,7 +371,8 @@
 	}
 	clk_prepare_enable(clk);
 
-	/* Arrange gpio_to_irq() support, handling either direct IRQs or
+	/*
+	 * Arrange gpio_to_irq() support, handling either direct IRQs or
 	 * banked IRQs.  Having GPIOs in the first GPIO bank use direct
 	 * IRQs, while the others use banked IRQs, would need some setup
 	 * tweaks to recognize hardware which can do that.
@@ -450,10 +454,11 @@
 	}
 
 done:
-	/* BINTEN -- per-bank interrupt enable. genirq would also let these
+	/*
+	 * BINTEN -- per-bank interrupt enable. genirq would also let these
 	 * bits be set/cleared dynamically.
 	 */
-	__raw_writel(binten, gpio_base + 0x08);
+	__raw_writel(binten, gpio_base + BINTEN);
 
 	printk(KERN_INFO "DaVinci: %d gpio irqs\n", irq - gpio_to_irq(0));