EMAC driver: add power down mode
This patch puts phy in power-down mode when interface is down.
Also we should think about energy detect power-down mode, that will
decrease power consumption when no link.
Signed-off-by: Vitja Makarov <vitja.makarov@gmail.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bfin_mac.c b/drivers/net/bfin_mac.c
index e9bd059..f2368b7 100644
--- a/drivers/net/bfin_mac.c
+++ b/drivers/net/bfin_mac.c
@@ -884,10 +884,10 @@
return retval;
phy_start(lp->phydev);
+ phy_write(lp->phydev, MII_BMCR, BMCR_RESET);
setup_system_regs(dev);
bf537mac_disable();
bf537mac_enable();
-
pr_debug("hardware init finished\n");
netif_start_queue(dev);
netif_carrier_on(dev);
@@ -910,6 +910,7 @@
netif_carrier_off(dev);
phy_stop(lp->phydev);
+ phy_write(lp->phydev, MII_BMCR, BMCR_PDOWN);
/* clear everything */
bf537mac_shutdown(dev);