[ARM] pxa: removing dead BACKLIGHT_CORGI
BACKLIGHT_CORGI was later renamed to BACKLIGHT_GENERIC and has not been
used since then. As it's now safe to completely transition to LCD_CORGI
driver, which incorprates both the LCD and backlight device.
Signed-off-by: Christoph Egger <siccegge@cs.fau.de>
Signed-off-by: Eric Miao <eric.y.miao@gmail.com>
diff --git a/arch/arm/mach-pxa/corgi_pm.c b/arch/arm/mach-pxa/corgi_pm.c
index 3f1dc74..a735205 100644
--- a/arch/arm/mach-pxa/corgi_pm.c
+++ b/arch/arm/mach-pxa/corgi_pm.c
@@ -165,8 +165,6 @@
.should_wakeup = corgi_should_wakeup,
#if defined(CONFIG_LCD_CORGI)
.backlight_limit = corgi_lcd_limit_intensity,
-#elif defined(CONFIG_BACKLIGHT_CORGI)
- .backlight_limit = corgibl_limit_intensity,
#endif
.charge_on_volt = SHARPSL_CHARGE_ON_VOLT,
.charge_on_temp = SHARPSL_CHARGE_ON_TEMP,
diff --git a/arch/arm/mach-pxa/sharpsl_pm.c b/arch/arm/mach-pxa/sharpsl_pm.c
index cb47672..582701e 100644
--- a/arch/arm/mach-pxa/sharpsl_pm.c
+++ b/arch/arm/mach-pxa/sharpsl_pm.c
@@ -277,21 +277,6 @@
dev_dbg(sharpsl_pm.dev, "Battery: voltage: %d, status: %d, percentage: %d, time: %ld\n", voltage,
sharpsl_pm.battstat.mainbat_status, sharpsl_pm.battstat.mainbat_percent, jiffies);
-#ifdef CONFIG_BACKLIGHT_CORGI
- /* If battery is low. limit backlight intensity to save power. */
- if ((sharpsl_pm.battstat.ac_status != APM_AC_ONLINE)
- && ((sharpsl_pm.battstat.mainbat_status == APM_BATTERY_STATUS_LOW)
- || (sharpsl_pm.battstat.mainbat_status == APM_BATTERY_STATUS_CRITICAL))) {
- if (!(sharpsl_pm.flags & SHARPSL_BL_LIMIT)) {
- sharpsl_pm.machinfo->backlight_limit(1);
- sharpsl_pm.flags |= SHARPSL_BL_LIMIT;
- }
- } else if (sharpsl_pm.flags & SHARPSL_BL_LIMIT) {
- sharpsl_pm.machinfo->backlight_limit(0);
- sharpsl_pm.flags &= ~SHARPSL_BL_LIMIT;
- }
-#endif
-
/* Suspend if critical battery level */
if ((sharpsl_pm.battstat.ac_status != APM_AC_ONLINE)
&& (sharpsl_pm.battstat.mainbat_status == APM_BATTERY_STATUS_CRITICAL)
diff --git a/arch/arm/mach-pxa/spitz_pm.c b/arch/arm/mach-pxa/spitz_pm.c
index 4209ddf..b36f0ae 100644
--- a/arch/arm/mach-pxa/spitz_pm.c
+++ b/arch/arm/mach-pxa/spitz_pm.c
@@ -212,8 +212,6 @@
.should_wakeup = spitz_should_wakeup,
#if defined(CONFIG_LCD_CORGI)
.backlight_limit = corgi_lcd_limit_intensity,
-#elif defined(CONFIG_BACKLIGHT_CORGI)
- .backlight_limit = corgibl_limit_intensity,
#endif
.charge_on_volt = SHARPSL_CHARGE_ON_VOLT,
.charge_on_temp = SHARPSL_CHARGE_ON_TEMP,