ARM: OMAP: Fix compile for beagle
Move twl4030 gpio init code to where it should be.
Also include twl4030.h.
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c
index 9e5ada0..38c88fb 100644
--- a/arch/arm/mach-omap2/board-omap3beagle.c
+++ b/arch/arm/mach-omap2/board-omap3beagle.c
@@ -28,6 +28,8 @@
#include <linux/mtd/partitions.h>
#include <linux/mtd/nand.h>
+#include <linux/i2c/twl4030.h>
+
#include <mach/hardware.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
@@ -120,6 +122,9 @@
unsigned gpio, unsigned ngpio)
{
/* gpio + 0 is "mmc0_cd" (input/IRQ) */
+ omap_cfg_reg(AH8_34XX_GPIO29);
+ mmc[0].gpio_cd = gpio + 0;
+ twl4030_mmc_init(mmc);
/* REVISIT: need ehci-omap hooks for external VBUS
* power switch and overcurrent detect
@@ -304,10 +309,6 @@
omap_board_config_size = ARRAY_SIZE(omap3_beagle_config);
omap_serial_init();
- omap_cfg_reg(AH8_34XX_GPIO29);
- mmc[0].gpio_cd = gpio + 0;
- twl4030_mmc_init(mmc);
-
omap_cfg_reg(J25_34XX_GPIO170);
gpio_request(170, "DVI_nPD");
/* REVISIT leave DVI powered down until it's needed ... */