[PATCH] Altix ioc4 serial - set hfc from ioctl
Allow hardware flow control to be set from an ioctl.
Signed-off-by: Patrick Gefre <pfg@sgi.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/serial/ioc4_serial.c b/drivers/serial/ioc4_serial.c
index d054f12..f94d2e7 100644
--- a/drivers/serial/ioc4_serial.c
+++ b/drivers/serial/ioc4_serial.c
@@ -1765,8 +1765,11 @@
the_port->ignore_status_mask &= ~N_DATA_READY;
}
- if (cflag & CRTSCTS)
+ if (cflag & CRTSCTS) {
info->flags |= ASYNC_CTS_FLOW;
+ port->ip_sscr |= IOC4_SSCR_HFC_EN;
+ writel(port->ip_sscr, &port->ip_serial_regs->sscr);
+ }
else
info->flags &= ~ASYNC_CTS_FLOW;
@@ -1825,12 +1828,6 @@
/* set the speed of the serial port */
ioc4_change_speed(the_port, info->tty->termios, (struct termios *)0);
- /* enable hardware flow control - after ioc4_change_speed because
- * ASYNC_CTS_FLOW is set there */
- if (info->flags & ASYNC_CTS_FLOW) {
- port->ip_sscr |= IOC4_SSCR_HFC_EN;
- writel(port->ip_sscr, &port->ip_serial_regs->sscr);
- }
info->flags |= UIF_INITIALIZED;
return 0;
}