| #ifndef CCISS_H |
| #define CCISS_H |
| |
| #include <linux/genhd.h> |
| |
| #include "cciss_cmd.h" |
| |
| |
| #define NWD 16 |
| #define NWD_SHIFT 4 |
| #define MAX_PART (1 << NWD_SHIFT) |
| |
| #define IO_OK 0 |
| #define IO_ERROR 1 |
| |
| struct ctlr_info; |
| typedef struct ctlr_info ctlr_info_t; |
| |
| struct access_method { |
| void (*submit_command)(ctlr_info_t *h, CommandList_struct *c); |
| void (*set_intr_mask)(ctlr_info_t *h, unsigned long val); |
| unsigned long (*fifo_full)(ctlr_info_t *h); |
| unsigned long (*intr_pending)(ctlr_info_t *h); |
| unsigned long (*command_completed)(ctlr_info_t *h); |
| }; |
| typedef struct _drive_info_struct |
| { |
| __u32 LunID; |
| int usage_count; |
| struct request_queue *queue; |
| sector_t nr_blocks; |
| int block_size; |
| int heads; |
| int sectors; |
| int cylinders; |
| int raid_level; /* set to -1 to indicate that |
| * the drive is not in use/configured |
| */ |
| int busy_configuring; /*This is set when the drive is being removed |
| *to prevent it from being opened or it's queue |
| *from being started. |
| */ |
| } drive_info_struct; |
| |
| #ifdef CONFIG_CISS_SCSI_TAPE |
| |
| struct sendcmd_reject_list { |
| int ncompletions; |
| unsigned long *complete; /* array of NR_CMDS tags */ |
| }; |
| |
| #endif |
| struct ctlr_info |
| { |
| int ctlr; |
| char devname[8]; |
| char *product_name; |
| char firm_ver[4]; // Firmware version |
| struct pci_dev *pdev; |
| __u32 board_id; |
| void __iomem *vaddr; |
| unsigned long paddr; |
| CfgTable_struct __iomem *cfgtable; |
| int interrupts_enabled; |
| int major; |
| int max_commands; |
| int commands_outstanding; |
| int max_outstanding; /* Debug */ |
| int num_luns; |
| int highest_lun; |
| int usage_count; /* number of opens all all minor devices */ |
| # define DOORBELL_INT 0 |
| # define PERF_MODE_INT 1 |
| # define SIMPLE_MODE_INT 2 |
| # define MEMQ_MODE_INT 3 |
| unsigned int intr[4]; |
| unsigned int msix_vector; |
| unsigned int msi_vector; |
| BYTE cciss_read; |
| BYTE cciss_write; |
| BYTE cciss_read_capacity; |
| |
| // information about each logical volume |
| drive_info_struct drv[CISS_MAX_LUN]; |
| |
| struct access_method access; |
| |
| /* queue and queue Info */ |
| CommandList_struct *reqQ; |
| CommandList_struct *cmpQ; |
| unsigned int Qdepth; |
| unsigned int maxQsinceinit; |
| unsigned int maxSG; |
| spinlock_t lock; |
| |
| //* pointers to command and error info pool */ |
| CommandList_struct *cmd_pool; |
| dma_addr_t cmd_pool_dhandle; |
| ErrorInfo_struct *errinfo_pool; |
| dma_addr_t errinfo_pool_dhandle; |
| unsigned long *cmd_pool_bits; |
| int nr_allocs; |
| int nr_frees; |
| int busy_configuring; |
| int busy_initializing; |
| |
| /* This element holds the zero based queue number of the last |
| * queue to be started. It is used for fairness. |
| */ |
| int next_to_run; |
| |
| // Disk structures we need to pass back |
| struct gendisk *gendisk[NWD]; |
| #ifdef CONFIG_CISS_SCSI_TAPE |
| void *scsi_ctlr; /* ptr to structure containing scsi related stuff */ |
| /* list of block side commands the scsi error handling sucked up */ |
| /* and saved for later processing */ |
| struct sendcmd_reject_list scsi_rejects; |
| #endif |
| unsigned char alive; |
| }; |
| |
| /* Defining the diffent access_menthods */ |
| /* |
| * Memory mapped FIFO interface (SMART 53xx cards) |
| */ |
| #define SA5_DOORBELL 0x20 |
| #define SA5_REQUEST_PORT_OFFSET 0x40 |
| #define SA5_REPLY_INTR_MASK_OFFSET 0x34 |
| #define SA5_REPLY_PORT_OFFSET 0x44 |
| #define SA5_INTR_STATUS 0x30 |
| #define SA5_SCRATCHPAD_OFFSET 0xB0 |
| |
| #define SA5_CTCFG_OFFSET 0xB4 |
| #define SA5_CTMEM_OFFSET 0xB8 |
| |
| #define SA5_INTR_OFF 0x08 |
| #define SA5B_INTR_OFF 0x04 |
| #define SA5_INTR_PENDING 0x08 |
| #define SA5B_INTR_PENDING 0x04 |
| #define FIFO_EMPTY 0xffffffff |
| #define CCISS_FIRMWARE_READY 0xffff0000 /* value in scratchpad register */ |
| |
| #define CISS_ERROR_BIT 0x02 |
| |
| #define CCISS_INTR_ON 1 |
| #define CCISS_INTR_OFF 0 |
| /* |
| Send the command to the hardware |
| */ |
| static void SA5_submit_command( ctlr_info_t *h, CommandList_struct *c) |
| { |
| #ifdef CCISS_DEBUG |
| printk("Sending %x - down to controller\n", c->busaddr ); |
| #endif /* CCISS_DEBUG */ |
| writel(c->busaddr, h->vaddr + SA5_REQUEST_PORT_OFFSET); |
| h->commands_outstanding++; |
| if ( h->commands_outstanding > h->max_outstanding) |
| h->max_outstanding = h->commands_outstanding; |
| } |
| |
| /* |
| * This card is the opposite of the other cards. |
| * 0 turns interrupts on... |
| * 0x08 turns them off... |
| */ |
| static void SA5_intr_mask(ctlr_info_t *h, unsigned long val) |
| { |
| if (val) |
| { /* Turn interrupts on */ |
| h->interrupts_enabled = 1; |
| writel(0, h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); |
| } else /* Turn them off */ |
| { |
| h->interrupts_enabled = 0; |
| writel( SA5_INTR_OFF, |
| h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); |
| } |
| } |
| /* |
| * This card is the opposite of the other cards. |
| * 0 turns interrupts on... |
| * 0x04 turns them off... |
| */ |
| static void SA5B_intr_mask(ctlr_info_t *h, unsigned long val) |
| { |
| if (val) |
| { /* Turn interrupts on */ |
| h->interrupts_enabled = 1; |
| writel(0, h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); |
| } else /* Turn them off */ |
| { |
| h->interrupts_enabled = 0; |
| writel( SA5B_INTR_OFF, |
| h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); |
| } |
| } |
| /* |
| * Returns true if fifo is full. |
| * |
| */ |
| static unsigned long SA5_fifo_full(ctlr_info_t *h) |
| { |
| if( h->commands_outstanding >= h->max_commands) |
| return(1); |
| else |
| return(0); |
| |
| } |
| /* |
| * returns value read from hardware. |
| * returns FIFO_EMPTY if there is nothing to read |
| */ |
| static unsigned long SA5_completed(ctlr_info_t *h) |
| { |
| unsigned long register_value |
| = readl(h->vaddr + SA5_REPLY_PORT_OFFSET); |
| if(register_value != FIFO_EMPTY) |
| { |
| h->commands_outstanding--; |
| #ifdef CCISS_DEBUG |
| printk("cciss: Read %lx back from board\n", register_value); |
| #endif /* CCISS_DEBUG */ |
| } |
| #ifdef CCISS_DEBUG |
| else |
| { |
| printk("cciss: FIFO Empty read\n"); |
| } |
| #endif |
| return ( register_value); |
| |
| } |
| /* |
| * Returns true if an interrupt is pending.. |
| */ |
| static unsigned long SA5_intr_pending(ctlr_info_t *h) |
| { |
| unsigned long register_value = |
| readl(h->vaddr + SA5_INTR_STATUS); |
| #ifdef CCISS_DEBUG |
| printk("cciss: intr_pending %lx\n", register_value); |
| #endif /* CCISS_DEBUG */ |
| if( register_value & SA5_INTR_PENDING) |
| return 1; |
| return 0 ; |
| } |
| |
| /* |
| * Returns true if an interrupt is pending.. |
| */ |
| static unsigned long SA5B_intr_pending(ctlr_info_t *h) |
| { |
| unsigned long register_value = |
| readl(h->vaddr + SA5_INTR_STATUS); |
| #ifdef CCISS_DEBUG |
| printk("cciss: intr_pending %lx\n", register_value); |
| #endif /* CCISS_DEBUG */ |
| if( register_value & SA5B_INTR_PENDING) |
| return 1; |
| return 0 ; |
| } |
| |
| |
| static struct access_method SA5_access = { |
| SA5_submit_command, |
| SA5_intr_mask, |
| SA5_fifo_full, |
| SA5_intr_pending, |
| SA5_completed, |
| }; |
| |
| static struct access_method SA5B_access = { |
| SA5_submit_command, |
| SA5B_intr_mask, |
| SA5_fifo_full, |
| SA5B_intr_pending, |
| SA5_completed, |
| }; |
| |
| struct board_type { |
| __u32 board_id; |
| char *product_name; |
| struct access_method *access; |
| }; |
| |
| #define CCISS_LOCK(i) (&hba[i]->lock) |
| |
| #endif /* CCISS_H */ |
| |