mlxsw: spectrum: Use per-FID struct for the VLAN-aware bridge
In a very similar way to the vFIDs, make the first 4K FIDs - used in the
VLAN-aware bridge - use the new FID struct.
Upon first use of the FID by any of the ports do the following:
1) Create the FID
2) Setup a matching flooding entry
3) Create a mapping for the FID
Unlike vFIDs, upon creation of a FID we always create a global
VID-to-FID mapping, so that ports without upper vPorts can use it
instead of creating an explicit {Port, VID} to FID mapping.
When a port leaves a FID the reverse is performed. Whenever the FID's
reference count reaches zero the FID is deleted along with the global
mapping.
The per-FID struct will later allow us to configure L3 interfaces on top
of the VLAN-aware bridge.
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/mellanox/mlxsw/spectrum.c b/drivers/net/ethernet/mellanox/mlxsw/spectrum.c
index 4869392..08f3f51 100644
--- a/drivers/net/ethernet/mellanox/mlxsw/spectrum.c
+++ b/drivers/net/ethernet/mellanox/mlxsw/spectrum.c
@@ -2396,6 +2396,7 @@
mlxsw_sp->core = mlxsw_core;
mlxsw_sp->bus_info = mlxsw_bus_info;
+ INIT_LIST_HEAD(&mlxsw_sp->fids);
INIT_LIST_HEAD(&mlxsw_sp->port_vfids.list);
INIT_LIST_HEAD(&mlxsw_sp->br_vfids.list);
INIT_LIST_HEAD(&mlxsw_sp->br_mids.list);
@@ -2472,6 +2473,7 @@
mlxsw_sp_traps_fini(mlxsw_sp);
mlxsw_sp_event_unregister(mlxsw_sp, MLXSW_TRAP_ID_PUDE);
mlxsw_sp_ports_remove(mlxsw_sp);
+ WARN_ON(!list_empty(&mlxsw_sp->fids));
}
static struct mlxsw_config_profile mlxsw_sp_config_profile = {