bnx2x: Don't allow VFs to become promiscuous
Currently, if a VF's Rx Mode will be configured to support promiscuous mode
the PF will comply, causing the VF to actually become promiscuous.
This will enable the VF to see all unicast traffic which might be intended for
other VMs, which we believe should not be possible.
This patch will cause the hypervisor to ignore the VF's request for changes in
its Rx mode (other than disabling it), preventing it from becoming promiscuous.
Reported-by: Yoann Juet <yoann.juet@univ-nantes.fr>
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: Ariel Elior <Ariel.Elior@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_vfpf.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_vfpf.c
index fe3737e..0622884 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_vfpf.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_vfpf.c
@@ -896,29 +896,16 @@
DP(NETIF_MSG_IFUP, "Rx mode is %d\n", mode);
- switch (mode) {
- case BNX2X_RX_MODE_NONE: /* no Rx */
+ /* Ignore everything accept MODE_NONE */
+ if (mode == BNX2X_RX_MODE_NONE) {
req->rx_mask = VFPF_RX_MASK_ACCEPT_NONE;
- break;
- case BNX2X_RX_MODE_NORMAL:
+ } else {
+ /* Current PF driver will not look at the specific flags,
+ * but they are required when working with older drivers on hv.
+ */
req->rx_mask = VFPF_RX_MASK_ACCEPT_MATCHED_MULTICAST;
req->rx_mask |= VFPF_RX_MASK_ACCEPT_MATCHED_UNICAST;
req->rx_mask |= VFPF_RX_MASK_ACCEPT_BROADCAST;
- break;
- case BNX2X_RX_MODE_ALLMULTI:
- req->rx_mask = VFPF_RX_MASK_ACCEPT_ALL_MULTICAST;
- req->rx_mask |= VFPF_RX_MASK_ACCEPT_MATCHED_UNICAST;
- req->rx_mask |= VFPF_RX_MASK_ACCEPT_BROADCAST;
- break;
- case BNX2X_RX_MODE_PROMISC:
- req->rx_mask = VFPF_RX_MASK_ACCEPT_ALL_UNICAST;
- req->rx_mask |= VFPF_RX_MASK_ACCEPT_ALL_MULTICAST;
- req->rx_mask |= VFPF_RX_MASK_ACCEPT_BROADCAST;
- break;
- default:
- BNX2X_ERR("BAD rx mode (%d)\n", mode);
- rc = -EINVAL;
- goto out;
}
req->flags |= VFPF_SET_Q_FILTERS_RX_MASK_CHANGED;
@@ -939,7 +926,7 @@
BNX2X_ERR("Set Rx mode failed: %d\n", resp->hdr.status);
rc = -EINVAL;
}
-out:
+
bnx2x_vfpf_finalize(bp, &req->first_tlv);
return rc;
@@ -1571,21 +1558,12 @@
struct pf_vf_bulletin_content *bulletin =
BP_VF_BULLETIN(bp, vf->index);
- /* covert VF-PF if mask to bnx2x accept flags */
- if (msg->rx_mask & VFPF_RX_MASK_ACCEPT_MATCHED_UNICAST)
+ /* Ignore VF requested mode; instead set a regular mode */
+ if (msg->rx_mask != VFPF_RX_MASK_ACCEPT_NONE) {
__set_bit(BNX2X_ACCEPT_UNICAST, &accept);
-
- if (msg->rx_mask & VFPF_RX_MASK_ACCEPT_MATCHED_MULTICAST)
__set_bit(BNX2X_ACCEPT_MULTICAST, &accept);
-
- if (msg->rx_mask & VFPF_RX_MASK_ACCEPT_ALL_UNICAST)
- __set_bit(BNX2X_ACCEPT_ALL_UNICAST, &accept);
-
- if (msg->rx_mask & VFPF_RX_MASK_ACCEPT_ALL_MULTICAST)
- __set_bit(BNX2X_ACCEPT_ALL_MULTICAST, &accept);
-
- if (msg->rx_mask & VFPF_RX_MASK_ACCEPT_BROADCAST)
__set_bit(BNX2X_ACCEPT_BROADCAST, &accept);
+ }
/* A packet arriving the vf's mac should be accepted
* with any vlan, unless a vlan has already been