PCI hotplug: pciehp: message refinement
This patch refines messages in pciehp module. The main changes are as
follows:
- remove the trailing "."
- remove __func__ as much as possible
- capitalize the first letter of messages
- show PCI device address including its domain
Signed-off-by: Taku Izumi <izumi.taku@jp.fujitsu.com>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/pci/hotplug/pciehp_pci.c b/drivers/pci/hotplug/pciehp_pci.c
index ffd1114..10f9566 100644
--- a/drivers/pci/hotplug/pciehp_pci.c
+++ b/drivers/pci/hotplug/pciehp_pci.c
@@ -39,8 +39,7 @@
u16 pci_cmd, pci_bctl;
if (hpp->revision > 1) {
- printk(KERN_WARNING "%s: Rev.%d type0 record not supported\n",
- __func__, hpp->revision);
+ warn("Rev.%d type0 record not supported\n", hpp->revision);
return;
}
@@ -81,8 +80,7 @@
u32 reg32;
if (hpp->revision > 1) {
- printk(KERN_WARNING "%s: Rev.%d type2 record not supported\n",
- __func__, hpp->revision);
+ warn("Rev.%d type2 record not supported\n", hpp->revision);
return;
}
@@ -149,8 +147,7 @@
return;
if (pciehp_get_hp_params_from_firmware(dev, &hpp)) {
- printk(KERN_WARNING "%s: Could not get hotplug parameters\n",
- __func__);
+ warn("Could not get hotplug parameters\n");
return;
}
@@ -202,9 +199,9 @@
dev = pci_get_slot(parent, PCI_DEVFN(p_slot->device, 0));
if (dev) {
- ctrl_err(ctrl,
- "Device %s already exists at %x:%x, cannot hot-add\n",
- pci_name(dev), p_slot->bus, p_slot->device);
+ ctrl_err(ctrl, "Device %s already exists "
+ "at %04x:%02x:%02x, cannot hot-add\n", pci_name(dev),
+ pci_domain_nr(parent), p_slot->bus, p_slot->device);
pci_dev_put(dev);
return -EINVAL;
}
@@ -248,8 +245,8 @@
u16 command;
struct controller *ctrl = p_slot->ctrl;
- ctrl_dbg(ctrl, "%s: bus/dev = %x/%x\n", __func__,
- p_slot->bus, p_slot->device);
+ ctrl_dbg(ctrl, "%s: domain:bus:dev = %04x:%02x:%02x\n",
+ __func__, pci_domain_nr(parent), p_slot->bus, p_slot->device);
ret = p_slot->hpc_ops->get_adapter_status(p_slot, &presence);
if (ret)
presence = 0;