| /* |
| * linux/drivers/ide/pci/slc90e66.c Version 0.15 Jul 6, 2007 |
| * |
| * Copyright (C) 2000-2002 Andre Hedrick <andre@linux-ide.org> |
| * Copyright (C) 2006-2007 MontaVista Software, Inc. <source@mvista.com> |
| * |
| * This is a look-alike variation of the ICH0 PIIX4 Ultra-66, |
| * but this keeps the ISA-Bridge and slots alive. |
| * |
| */ |
| |
| #include <linux/types.h> |
| #include <linux/module.h> |
| #include <linux/kernel.h> |
| #include <linux/ioport.h> |
| #include <linux/pci.h> |
| #include <linux/hdreg.h> |
| #include <linux/ide.h> |
| #include <linux/delay.h> |
| #include <linux/init.h> |
| |
| #include <asm/io.h> |
| |
| static u8 slc90e66_dma_2_pio (u8 xfer_rate) { |
| switch(xfer_rate) { |
| case XFER_UDMA_4: |
| case XFER_UDMA_3: |
| case XFER_UDMA_2: |
| case XFER_UDMA_1: |
| case XFER_UDMA_0: |
| case XFER_MW_DMA_2: |
| return 4; |
| case XFER_MW_DMA_1: |
| return 3; |
| case XFER_SW_DMA_2: |
| return 2; |
| case XFER_MW_DMA_0: |
| case XFER_SW_DMA_1: |
| case XFER_SW_DMA_0: |
| default: |
| return 0; |
| } |
| } |
| |
| static void slc90e66_tune_pio (ide_drive_t *drive, u8 pio) |
| { |
| ide_hwif_t *hwif = HWIF(drive); |
| struct pci_dev *dev = hwif->pci_dev; |
| int is_slave = drive->dn & 1; |
| int master_port = hwif->channel ? 0x42 : 0x40; |
| int slave_port = 0x44; |
| unsigned long flags; |
| u16 master_data; |
| u8 slave_data; |
| int control = 0; |
| /* ISP RTC */ |
| static const u8 timings[][2]= { |
| { 0, 0 }, |
| { 0, 0 }, |
| { 1, 0 }, |
| { 2, 1 }, |
| { 2, 3 }, }; |
| |
| spin_lock_irqsave(&ide_lock, flags); |
| pci_read_config_word(dev, master_port, &master_data); |
| |
| if (pio > 1) |
| control |= 1; /* Programmable timing on */ |
| if (drive->media == ide_disk) |
| control |= 4; /* Prefetch, post write */ |
| if (pio > 2) |
| control |= 2; /* IORDY */ |
| if (is_slave) { |
| master_data |= 0x4000; |
| master_data &= ~0x0070; |
| if (pio > 1) { |
| /* Set PPE, IE and TIME */ |
| master_data |= control << 4; |
| } |
| pci_read_config_byte(dev, slave_port, &slave_data); |
| slave_data &= hwif->channel ? 0x0f : 0xf0; |
| slave_data |= ((timings[pio][0] << 2) | timings[pio][1]) << |
| (hwif->channel ? 4 : 0); |
| } else { |
| master_data &= ~0x3307; |
| if (pio > 1) { |
| /* enable PPE, IE and TIME */ |
| master_data |= control; |
| } |
| master_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8); |
| } |
| pci_write_config_word(dev, master_port, master_data); |
| if (is_slave) |
| pci_write_config_byte(dev, slave_port, slave_data); |
| spin_unlock_irqrestore(&ide_lock, flags); |
| } |
| |
| static void slc90e66_tune_drive (ide_drive_t *drive, u8 pio) |
| { |
| pio = ide_get_best_pio_mode(drive, pio, 4); |
| slc90e66_tune_pio(drive, pio); |
| (void) ide_config_drive_speed(drive, XFER_PIO_0 + pio); |
| } |
| |
| static int slc90e66_tune_chipset (ide_drive_t *drive, u8 xferspeed) |
| { |
| ide_hwif_t *hwif = HWIF(drive); |
| struct pci_dev *dev = hwif->pci_dev; |
| u8 maslave = hwif->channel ? 0x42 : 0x40; |
| u8 speed = ide_rate_filter(drive, xferspeed); |
| int sitre = 0, a_speed = 7 << (drive->dn * 4); |
| int u_speed = 0, u_flag = 1 << drive->dn; |
| u16 reg4042, reg44, reg48, reg4a; |
| |
| pci_read_config_word(dev, maslave, ®4042); |
| sitre = (reg4042 & 0x4000) ? 1 : 0; |
| pci_read_config_word(dev, 0x44, ®44); |
| pci_read_config_word(dev, 0x48, ®48); |
| pci_read_config_word(dev, 0x4a, ®4a); |
| |
| switch(speed) { |
| case XFER_UDMA_4: u_speed = 4 << (drive->dn * 4); break; |
| case XFER_UDMA_3: u_speed = 3 << (drive->dn * 4); break; |
| case XFER_UDMA_2: u_speed = 2 << (drive->dn * 4); break; |
| case XFER_UDMA_1: u_speed = 1 << (drive->dn * 4); break; |
| case XFER_UDMA_0: u_speed = 0 << (drive->dn * 4); break; |
| case XFER_MW_DMA_2: |
| case XFER_MW_DMA_1: |
| case XFER_SW_DMA_2: break; |
| case XFER_PIO_4: |
| case XFER_PIO_3: |
| case XFER_PIO_2: |
| case XFER_PIO_1: |
| case XFER_PIO_0: break; |
| default: return -1; |
| } |
| |
| if (speed >= XFER_UDMA_0) { |
| if (!(reg48 & u_flag)) |
| pci_write_config_word(dev, 0x48, reg48|u_flag); |
| /* FIXME: (reg4a & a_speed) ? */ |
| if ((reg4a & u_speed) != u_speed) { |
| pci_write_config_word(dev, 0x4a, reg4a & ~a_speed); |
| pci_read_config_word(dev, 0x4a, ®4a); |
| pci_write_config_word(dev, 0x4a, reg4a|u_speed); |
| } |
| } else { |
| if (reg48 & u_flag) |
| pci_write_config_word(dev, 0x48, reg48 & ~u_flag); |
| if (reg4a & a_speed) |
| pci_write_config_word(dev, 0x4a, reg4a & ~a_speed); |
| } |
| |
| if (speed > XFER_PIO_4) |
| slc90e66_tune_pio(drive, slc90e66_dma_2_pio(speed)); |
| else |
| slc90e66_tune_pio(drive, speed - XFER_PIO_0); |
| |
| return ide_config_drive_speed(drive, speed); |
| } |
| |
| static int slc90e66_config_drive_xfer_rate (ide_drive_t *drive) |
| { |
| drive->init_speed = 0; |
| |
| if (ide_tune_dma(drive)) |
| return 0; |
| |
| if (ide_use_fast_pio(drive)) |
| slc90e66_tune_drive(drive, 255); |
| |
| return -1; |
| } |
| |
| static void __devinit init_hwif_slc90e66 (ide_hwif_t *hwif) |
| { |
| u8 reg47 = 0; |
| u8 mask = hwif->channel ? 0x01 : 0x02; /* bit0:Primary */ |
| |
| hwif->autodma = 0; |
| |
| if (!hwif->irq) |
| hwif->irq = hwif->channel ? 15 : 14; |
| |
| hwif->speedproc = &slc90e66_tune_chipset; |
| hwif->tuneproc = &slc90e66_tune_drive; |
| |
| pci_read_config_byte(hwif->pci_dev, 0x47, ®47); |
| |
| if (!hwif->dma_base) { |
| hwif->drives[0].autotune = 1; |
| hwif->drives[1].autotune = 1; |
| return; |
| } |
| |
| hwif->atapi_dma = 1; |
| hwif->ultra_mask = 0x1f; |
| hwif->mwdma_mask = 0x06; |
| hwif->swdma_mask = 0x04; |
| |
| if (hwif->cbl != ATA_CBL_PATA40_SHORT) |
| /* bit[0(1)]: 0:80, 1:40 */ |
| hwif->cbl = (reg47 & mask) ? ATA_CBL_PATA40 : ATA_CBL_PATA80; |
| |
| hwif->ide_dma_check = &slc90e66_config_drive_xfer_rate; |
| |
| if (!noautodma) |
| hwif->autodma = 1; |
| hwif->drives[0].autodma = hwif->autodma; |
| hwif->drives[1].autodma = hwif->autodma; |
| } |
| |
| static ide_pci_device_t slc90e66_chipset __devinitdata = { |
| .name = "SLC90E66", |
| .init_hwif = init_hwif_slc90e66, |
| .autodma = AUTODMA, |
| .enablebits = {{0x41,0x80,0x80}, {0x43,0x80,0x80}}, |
| .bootable = ON_BOARD, |
| .pio_mask = ATA_PIO4, |
| }; |
| |
| static int __devinit slc90e66_init_one(struct pci_dev *dev, const struct pci_device_id *id) |
| { |
| return ide_setup_pci_device(dev, &slc90e66_chipset); |
| } |
| |
| static struct pci_device_id slc90e66_pci_tbl[] = { |
| { PCI_DEVICE(PCI_VENDOR_ID_EFAR, PCI_DEVICE_ID_EFAR_SLC90E66_1), 0}, |
| { 0, }, |
| }; |
| MODULE_DEVICE_TABLE(pci, slc90e66_pci_tbl); |
| |
| static struct pci_driver driver = { |
| .name = "SLC90e66_IDE", |
| .id_table = slc90e66_pci_tbl, |
| .probe = slc90e66_init_one, |
| }; |
| |
| static int __init slc90e66_ide_init(void) |
| { |
| return ide_pci_register_driver(&driver); |
| } |
| |
| module_init(slc90e66_ide_init); |
| |
| MODULE_AUTHOR("Andre Hedrick"); |
| MODULE_DESCRIPTION("PCI driver module for SLC90E66 IDE"); |
| MODULE_LICENSE("GPL"); |