qed: Add missing 100g init mode
Some of the HW configurations are currently missing for 100g devices.
This can cause various classification issues, as well as prevent device
from fully reaching line-rate.
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_dev.c b/drivers/net/ethernet/qlogic/qed/qed_dev.c
index 920eadd..2a7c875 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_dev.c
+++ b/drivers/net/ethernet/qlogic/qed/qed_dev.c
@@ -588,7 +588,14 @@
hw_mode |= 1 << MODE_ASIC;
+ if (p_hwfn->cdev->num_hwfns > 1)
+ hw_mode |= 1 << MODE_100G;
+
p_hwfn->hw_info.hw_mode = hw_mode;
+
+ DP_VERBOSE(p_hwfn, (NETIF_MSG_PROBE | NETIF_MSG_IFUP),
+ "Configuring function for hw_mode: 0x%08x\n",
+ p_hwfn->hw_info.hw_mode);
}
/* Init run time data for all PFs on an engine. */