pinctrl/nomadik: allow to support several ranges per GPIO bank
With DB8500 the number of GPIO chips = number GPIO bank =
number of GPIO ranges.
With DB8540, a new GPIO range configuration is used, some GPIO
banks can have several GPIO ranges.
For example, DB8540 GPIO bank0 (GPIO0 to GPIO32) have 2 GPIO
ranges:
- GPIO0 to GPIO17 : routed
- GPIO18 to GPIO21 : hole
- GPIO22 to GPIO28 : routed
- GPIO29 to GPIO32 : hole
Previously, during nmk_pinctrl_probe(), all GPIO ranges were
parsed, as GPIO ranges are larger than the number of GPIO chips,
a warning occurs. This commit allows each bank to have several
GPIO ranges.
Signed-off-by: Patrice Chotard <patrice.chotard@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/pinctrl-nomadik.c b/drivers/pinctrl/pinctrl-nomadik.c
index f5c0da1..e30eb34 100644
--- a/drivers/pinctrl/pinctrl-nomadik.c
+++ b/drivers/pinctrl/pinctrl-nomadik.c
@@ -1843,11 +1843,11 @@
* need this to proceed.
*/
for (i = 0; i < npct->soc->gpio_num_ranges; i++) {
- if (!nmk_gpio_chips[i]) {
+ if (!nmk_gpio_chips[npct->soc->gpio_ranges[i].id]) {
dev_warn(&pdev->dev, "GPIO chip %d not registered yet\n", i);
return -EPROBE_DEFER;
}
- npct->soc->gpio_ranges[i].gc = &nmk_gpio_chips[i]->chip;
+ npct->soc->gpio_ranges[i].gc = &nmk_gpio_chips[npct->soc->gpio_ranges[i].id]->chip;
}
nmk_pinctrl_desc.pins = npct->soc->pins;