Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/scsi/sata_sis.c b/drivers/scsi/sata_sis.c
new file mode 100644
index 0000000..5105ddd
--- /dev/null
+++ b/drivers/scsi/sata_sis.c
@@ -0,0 +1,286 @@
+/*
+ * sata_sis.c - Silicon Integrated Systems SATA
+ *
+ * Maintained by: Uwe Koziolek
+ * Please ALWAYS copy linux-ide@vger.kernel.org
+ * on emails.
+ *
+ * Copyright 2004 Uwe Koziolek
+ *
+ * The contents of this file are subject to the Open
+ * Software License version 1.1 that can be found at
+ * http://www.opensource.org/licenses/osl-1.1.txt and is included herein
+ * by reference.
+ *
+ * Alternatively, the contents of this file may be used under the terms
+ * of the GNU General Public License version 2 (the "GPL") as distributed
+ * in the kernel source COPYING file, in which case the provisions of
+ * the GPL are applicable instead of the above. If you wish to allow
+ * the use of your version of this file only under the terms of the
+ * GPL and not to allow others to use your version of this file under
+ * the OSL, indicate your decision by deleting the provisions above and
+ * replace them with the notice and other provisions required by the GPL.
+ * If you do not delete the provisions above, a recipient may use your
+ * version of this file under either the OSL or the GPL.
+ *
+ */
+
+#include <linux/config.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/pci.h>
+#include <linux/init.h>
+#include <linux/blkdev.h>
+#include <linux/delay.h>
+#include <linux/interrupt.h>
+#include "scsi.h"
+#include <scsi/scsi_host.h>
+#include <linux/libata.h>
+
+#define DRV_NAME "sata_sis"
+#define DRV_VERSION "0.5"
+
+enum {
+ sis_180 = 0,
+ SIS_SCR_PCI_BAR = 5,
+
+ /* PCI configuration registers */
+ SIS_GENCTL = 0x54, /* IDE General Control register */
+ SIS_SCR_BASE = 0xc0, /* sata0 phy SCR registers */
+ SIS_SATA1_OFS = 0x10, /* offset from sata0->sata1 phy regs */
+
+ /* random bits */
+ SIS_FLAG_CFGSCR = (1 << 30), /* host flag: SCRs via PCI cfg */
+
+ GENCTL_IOMAPPED_SCR = (1 << 26), /* if set, SCRs are in IO space */
+};
+
+static int sis_init_one (struct pci_dev *pdev, const struct pci_device_id *ent);
+static u32 sis_scr_read (struct ata_port *ap, unsigned int sc_reg);
+static void sis_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
+
+static struct pci_device_id sis_pci_tbl[] = {
+ { PCI_VENDOR_ID_SI, 0x180, PCI_ANY_ID, PCI_ANY_ID, 0, 0, sis_180 },
+ { PCI_VENDOR_ID_SI, 0x181, PCI_ANY_ID, PCI_ANY_ID, 0, 0, sis_180 },
+ { } /* terminate list */
+};
+
+
+static struct pci_driver sis_pci_driver = {
+ .name = DRV_NAME,
+ .id_table = sis_pci_tbl,
+ .probe = sis_init_one,
+ .remove = ata_pci_remove_one,
+};
+
+static Scsi_Host_Template sis_sht = {
+ .module = THIS_MODULE,
+ .name = DRV_NAME,
+ .ioctl = ata_scsi_ioctl,
+ .queuecommand = ata_scsi_queuecmd,
+ .eh_strategy_handler = ata_scsi_error,
+ .can_queue = ATA_DEF_QUEUE,
+ .this_id = ATA_SHT_THIS_ID,
+ .sg_tablesize = ATA_MAX_PRD,
+ .max_sectors = ATA_MAX_SECTORS,
+ .cmd_per_lun = ATA_SHT_CMD_PER_LUN,
+ .emulated = ATA_SHT_EMULATED,
+ .use_clustering = ATA_SHT_USE_CLUSTERING,
+ .proc_name = DRV_NAME,
+ .dma_boundary = ATA_DMA_BOUNDARY,
+ .slave_configure = ata_scsi_slave_config,
+ .bios_param = ata_std_bios_param,
+ .ordered_flush = 1,
+};
+
+static struct ata_port_operations sis_ops = {
+ .port_disable = ata_port_disable,
+ .tf_load = ata_tf_load,
+ .tf_read = ata_tf_read,
+ .check_status = ata_check_status,
+ .exec_command = ata_exec_command,
+ .dev_select = ata_std_dev_select,
+ .phy_reset = sata_phy_reset,
+ .bmdma_setup = ata_bmdma_setup,
+ .bmdma_start = ata_bmdma_start,
+ .bmdma_stop = ata_bmdma_stop,
+ .bmdma_status = ata_bmdma_status,
+ .qc_prep = ata_qc_prep,
+ .qc_issue = ata_qc_issue_prot,
+ .eng_timeout = ata_eng_timeout,
+ .irq_handler = ata_interrupt,
+ .irq_clear = ata_bmdma_irq_clear,
+ .scr_read = sis_scr_read,
+ .scr_write = sis_scr_write,
+ .port_start = ata_port_start,
+ .port_stop = ata_port_stop,
+};
+
+static struct ata_port_info sis_port_info = {
+ .sht = &sis_sht,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
+ ATA_FLAG_NO_LEGACY,
+ .pio_mask = 0x1f,
+ .mwdma_mask = 0x7,
+ .udma_mask = 0x7f,
+ .port_ops = &sis_ops,
+};
+
+
+MODULE_AUTHOR("Uwe Koziolek");
+MODULE_DESCRIPTION("low-level driver for Silicon Integratad Systems SATA controller");
+MODULE_LICENSE("GPL");
+MODULE_DEVICE_TABLE(pci, sis_pci_tbl);
+MODULE_VERSION(DRV_VERSION);
+
+static unsigned int get_scr_cfg_addr(unsigned int port_no, unsigned int sc_reg)
+{
+ unsigned int addr = SIS_SCR_BASE + (4 * sc_reg);
+
+ if (port_no)
+ addr += SIS_SATA1_OFS;
+ return addr;
+}
+
+static u32 sis_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg)
+{
+ struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
+ unsigned int cfg_addr = get_scr_cfg_addr(ap->port_no, sc_reg);
+ u32 val;
+
+ if (sc_reg == SCR_ERROR) /* doesn't exist in PCI cfg space */
+ return 0xffffffff;
+ pci_read_config_dword(pdev, cfg_addr, &val);
+ return val;
+}
+
+static void sis_scr_cfg_write (struct ata_port *ap, unsigned int scr, u32 val)
+{
+ struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
+ unsigned int cfg_addr = get_scr_cfg_addr(ap->port_no, scr);
+
+ if (scr == SCR_ERROR) /* doesn't exist in PCI cfg space */
+ return;
+ pci_write_config_dword(pdev, cfg_addr, val);
+}
+
+static u32 sis_scr_read (struct ata_port *ap, unsigned int sc_reg)
+{
+ if (sc_reg > SCR_CONTROL)
+ return 0xffffffffU;
+
+ if (ap->flags & SIS_FLAG_CFGSCR)
+ return sis_scr_cfg_read(ap, sc_reg);
+ return inl(ap->ioaddr.scr_addr + (sc_reg * 4));
+}
+
+static void sis_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val)
+{
+ if (sc_reg > SCR_CONTROL)
+ return;
+
+ if (ap->flags & SIS_FLAG_CFGSCR)
+ sis_scr_cfg_write(ap, sc_reg, val);
+ else
+ outl(val, ap->ioaddr.scr_addr + (sc_reg * 4));
+}
+
+/* move to PCI layer, integrate w/ MSI stuff */
+static void pci_enable_intx(struct pci_dev *pdev)
+{
+ u16 pci_command;
+
+ pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
+ if (pci_command & PCI_COMMAND_INTX_DISABLE) {
+ pci_command &= ~PCI_COMMAND_INTX_DISABLE;
+ pci_write_config_word(pdev, PCI_COMMAND, pci_command);
+ }
+}
+
+static int sis_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
+{
+ struct ata_probe_ent *probe_ent = NULL;
+ int rc;
+ u32 genctl;
+ struct ata_port_info *ppi;
+ int pci_dev_busy = 0;
+
+ rc = pci_enable_device(pdev);
+ if (rc)
+ return rc;
+
+ rc = pci_request_regions(pdev, DRV_NAME);
+ if (rc) {
+ pci_dev_busy = 1;
+ goto err_out;
+ }
+
+ rc = pci_set_dma_mask(pdev, ATA_DMA_MASK);
+ if (rc)
+ goto err_out_regions;
+ rc = pci_set_consistent_dma_mask(pdev, ATA_DMA_MASK);
+ if (rc)
+ goto err_out_regions;
+
+ ppi = &sis_port_info;
+ probe_ent = ata_pci_init_native_mode(pdev, &ppi);
+ if (!probe_ent) {
+ rc = -ENOMEM;
+ goto err_out_regions;
+ }
+
+ /* check and see if the SCRs are in IO space or PCI cfg space */
+ pci_read_config_dword(pdev, SIS_GENCTL, &genctl);
+ if ((genctl & GENCTL_IOMAPPED_SCR) == 0)
+ probe_ent->host_flags |= SIS_FLAG_CFGSCR;
+
+ /* if hardware thinks SCRs are in IO space, but there are
+ * no IO resources assigned, change to PCI cfg space.
+ */
+ if ((!(probe_ent->host_flags & SIS_FLAG_CFGSCR)) &&
+ ((pci_resource_start(pdev, SIS_SCR_PCI_BAR) == 0) ||
+ (pci_resource_len(pdev, SIS_SCR_PCI_BAR) < 128))) {
+ genctl &= ~GENCTL_IOMAPPED_SCR;
+ pci_write_config_dword(pdev, SIS_GENCTL, genctl);
+ probe_ent->host_flags |= SIS_FLAG_CFGSCR;
+ }
+
+ if (!(probe_ent->host_flags & SIS_FLAG_CFGSCR)) {
+ probe_ent->port[0].scr_addr =
+ pci_resource_start(pdev, SIS_SCR_PCI_BAR);
+ probe_ent->port[1].scr_addr =
+ pci_resource_start(pdev, SIS_SCR_PCI_BAR) + 64;
+ }
+
+ pci_set_master(pdev);
+ pci_enable_intx(pdev);
+
+ /* FIXME: check ata_device_add return value */
+ ata_device_add(probe_ent);
+ kfree(probe_ent);
+
+ return 0;
+
+err_out_regions:
+ pci_release_regions(pdev);
+
+err_out:
+ if (!pci_dev_busy)
+ pci_disable_device(pdev);
+ return rc;
+
+}
+
+static int __init sis_init(void)
+{
+ return pci_module_init(&sis_pci_driver);
+}
+
+static void __exit sis_exit(void)
+{
+ pci_unregister_driver(&sis_pci_driver);
+}
+
+module_init(sis_init);
+module_exit(sis_exit);
+