| #ifndef LINUX_SSB_DRIVER_GIGE_H_ |
| #define LINUX_SSB_DRIVER_GIGE_H_ |
| |
| #include <linux/ssb/ssb.h> |
| #include <linux/pci.h> |
| #include <linux/spinlock.h> |
| |
| |
| #ifdef CONFIG_SSB_DRIVER_GIGE |
| |
| |
| #define SSB_GIGE_PCIIO 0x0000 /* PCI I/O Registers (1024 bytes) */ |
| #define SSB_GIGE_RESERVED 0x0400 /* Reserved (1024 bytes) */ |
| #define SSB_GIGE_PCICFG 0x0800 /* PCI config space (256 bytes) */ |
| #define SSB_GIGE_SHIM_FLUSHSTAT 0x0C00 /* PCI to OCP: Flush status control (32bit) */ |
| #define SSB_GIGE_SHIM_FLUSHRDA 0x0C04 /* PCI to OCP: Flush read address (32bit) */ |
| #define SSB_GIGE_SHIM_FLUSHTO 0x0C08 /* PCI to OCP: Flush timeout counter (32bit) */ |
| #define SSB_GIGE_SHIM_BARRIER 0x0C0C /* PCI to OCP: Barrier register (32bit) */ |
| #define SSB_GIGE_SHIM_MAOCPSI 0x0C10 /* PCI to OCP: MaocpSI Control (32bit) */ |
| #define SSB_GIGE_SHIM_SIOCPMA 0x0C14 /* PCI to OCP: SiocpMa Control (32bit) */ |
| |
| /* TM Status High flags */ |
| #define SSB_GIGE_TMSHIGH_RGMII 0x00010000 /* Have an RGMII PHY-bus */ |
| /* TM Status Low flags */ |
| #define SSB_GIGE_TMSLOW_TXBYPASS 0x00080000 /* TX bypass (no delay) */ |
| #define SSB_GIGE_TMSLOW_RXBYPASS 0x00100000 /* RX bypass (no delay) */ |
| #define SSB_GIGE_TMSLOW_DLLEN 0x01000000 /* Enable DLL controls */ |
| |
| /* Boardflags (low) */ |
| #define SSB_GIGE_BFL_ROBOSWITCH 0x0010 |
| |
| |
| #define SSB_GIGE_MEM_RES_NAME "SSB Broadcom 47xx GigE memory" |
| #define SSB_GIGE_IO_RES_NAME "SSB Broadcom 47xx GigE I/O" |
| |
| struct ssb_gige { |
| struct ssb_device *dev; |
| |
| spinlock_t lock; |
| |
| /* True, if the device has an RGMII bus. |
| * False, if the device has a GMII bus. */ |
| bool has_rgmii; |
| |
| /* The PCI controller device. */ |
| struct pci_controller pci_controller; |
| struct pci_ops pci_ops; |
| struct resource mem_resource; |
| struct resource io_resource; |
| }; |
| |
| /* Check whether a PCI device is a SSB Gigabit Ethernet core. */ |
| extern bool pdev_is_ssb_gige_core(struct pci_dev *pdev); |
| |
| /* Convert a pci_dev pointer to a ssb_gige pointer. */ |
| static inline struct ssb_gige * pdev_to_ssb_gige(struct pci_dev *pdev) |
| { |
| if (!pdev_is_ssb_gige_core(pdev)) |
| return NULL; |
| return container_of(pdev->bus->ops, struct ssb_gige, pci_ops); |
| } |
| |
| /* Returns whether the PHY is connected by an RGMII bus. */ |
| static inline bool ssb_gige_is_rgmii(struct pci_dev *pdev) |
| { |
| struct ssb_gige *dev = pdev_to_ssb_gige(pdev); |
| return (dev ? dev->has_rgmii : 0); |
| } |
| |
| /* Returns whether we have a Roboswitch. */ |
| static inline bool ssb_gige_have_roboswitch(struct pci_dev *pdev) |
| { |
| struct ssb_gige *dev = pdev_to_ssb_gige(pdev); |
| if (dev) |
| return !!(dev->dev->bus->sprom.boardflags_lo & |
| SSB_GIGE_BFL_ROBOSWITCH); |
| return 0; |
| } |
| |
| /* Returns whether we can only do one DMA at once. */ |
| static inline bool ssb_gige_one_dma_at_once(struct pci_dev *pdev) |
| { |
| struct ssb_gige *dev = pdev_to_ssb_gige(pdev); |
| if (dev) |
| return ((dev->dev->bus->chip_id == 0x4785) && |
| (dev->dev->bus->chip_rev < 2)); |
| return 0; |
| } |
| |
| /* Returns whether we must flush posted writes. */ |
| static inline bool ssb_gige_must_flush_posted_writes(struct pci_dev *pdev) |
| { |
| struct ssb_gige *dev = pdev_to_ssb_gige(pdev); |
| if (dev) |
| return (dev->dev->bus->chip_id == 0x4785); |
| return 0; |
| } |
| |
| extern char * nvram_get(const char *name); |
| /* Get the device MAC address */ |
| static inline void ssb_gige_get_macaddr(struct pci_dev *pdev, u8 *macaddr) |
| { |
| #ifdef CONFIG_BCM947XX |
| char *res = nvram_get("et0macaddr"); |
| if (res) |
| memcpy(macaddr, res, 6); |
| #endif |
| } |
| |
| extern int ssb_gige_pcibios_plat_dev_init(struct ssb_device *sdev, |
| struct pci_dev *pdev); |
| extern int ssb_gige_map_irq(struct ssb_device *sdev, |
| const struct pci_dev *pdev); |
| |
| /* The GigE driver is not a standalone module, because we don't have support |
| * for unregistering the driver. So we could not unload the module anyway. */ |
| extern int ssb_gige_init(void); |
| static inline void ssb_gige_exit(void) |
| { |
| /* Currently we can not unregister the GigE driver, |
| * because we can not unregister the PCI bridge. */ |
| BUG(); |
| } |
| |
| |
| #else /* CONFIG_SSB_DRIVER_GIGE */ |
| /* Gigabit Ethernet driver disabled */ |
| |
| |
| static inline int ssb_gige_pcibios_plat_dev_init(struct ssb_device *sdev, |
| struct pci_dev *pdev) |
| { |
| return -ENOSYS; |
| } |
| static inline int ssb_gige_map_irq(struct ssb_device *sdev, |
| const struct pci_dev *pdev) |
| { |
| return -ENOSYS; |
| } |
| static inline int ssb_gige_init(void) |
| { |
| return 0; |
| } |
| static inline void ssb_gige_exit(void) |
| { |
| } |
| |
| static inline bool pdev_is_ssb_gige_core(struct pci_dev *pdev) |
| { |
| return 0; |
| } |
| static inline struct ssb_gige * pdev_to_ssb_gige(struct pci_dev *pdev) |
| { |
| return NULL; |
| } |
| static inline bool ssb_gige_is_rgmii(struct pci_dev *pdev) |
| { |
| return 0; |
| } |
| static inline bool ssb_gige_have_roboswitch(struct pci_dev *pdev) |
| { |
| return 0; |
| } |
| static inline bool ssb_gige_one_dma_at_once(struct pci_dev *pdev) |
| { |
| return 0; |
| } |
| static inline bool ssb_gige_must_flush_posted_writes(struct pci_dev *pdev) |
| { |
| return 0; |
| } |
| |
| #endif /* CONFIG_SSB_DRIVER_GIGE */ |
| #endif /* LINUX_SSB_DRIVER_GIGE_H_ */ |