IB/mthca: Make fw_cmd_doorbell default to 0
Setting fw_cmd_doorbell allows FW command to be queued using posted
writes instead of requiring polling on a "go" bit, so it should be a
performance boost. However, the option causes problems with at least
some device/firmware combinations, so set the default to 0 until we
understand what's going on better.
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/mthca/mthca_cmd.c b/drivers/infiniband/hw/mthca/mthca_cmd.c
index 1985b5d..798e13e 100644
--- a/drivers/infiniband/hw/mthca/mthca_cmd.c
+++ b/drivers/infiniband/hw/mthca/mthca_cmd.c
@@ -182,7 +182,7 @@
u8 status;
};
-static int fw_cmd_doorbell = 1;
+static int fw_cmd_doorbell = 0;
module_param(fw_cmd_doorbell, int, 0644);
MODULE_PARM_DESC(fw_cmd_doorbell, "post FW commands through doorbell page if nonzero "
"(and supported by FW)");